Effect of Zn(S,O,OH) Buffer Thin Films Formed on CIGS Through Different Stages and Reaction Processes in Chemical Bath Deposition: Interpretations from Mechanisms and Transformation Kinetics Perspective
Ara Cho,Marlena Ostrysz,Soomin Song,Donghyeop Shin,Inyoung Jeong,Young-Joo Eo,Seung Kyu Ahn,Kihwan Kim,Joo Hyung Park
DOI: https://doi.org/10.1002/solr.202200152
IF: 9.1726
2022-01-01
Solar RRL
Abstract:Herein, Zn(S,O,OH) is used as a buffer material for Cu(In,Ga)Se2 (CIGS) solar cells instead of CdS to increase the quantum efficiency and remove toxicity. To control the fine thickness of the Zn(S,O,OH) thin films in the chemical bath deposition (CBD) method, a quartz crystal microbalance (QCM) system is introduced by measuring the frequency change. As the frequency changes are adjusted according to the S/O ratio of the Zn(S,O,OH) buffer (Zn buffer) produced during the reaction, the formed phase and thickness are cross‐validated several times to obtain the accurate thickness. These different S/O ratios can be modified by different deposition mechanisms and reaction processes depending on the reaction rate of material formation. Therefore, to investigate the associated mechanism and reaction process in detail, Zn buffer thin films are formed and characterized using two different Zn sources (zinc sulfate and zinc acetate) that affect the reaction rate due to the anion effect. In addition, the optimal deposition range is obtained by comparing the performances of the solar cells with Zn thin films of the same thickness, deposited through different stages in a continuous CBD reaction. Finally, the effect of Zn buffers using different Zn sources on the interfaces with CIGS is investigated in the band alignment.