Abstract:The energy transfer and conversion of exhaust gas flowing across junctions of exhaust manifold plays an important role in determining performance of turbocharging system. With the increase of engine boost pressure, exhaust gas velocity increases significantly, which increased compressibility of exhaust gas flow simultaneously. The existed exhaust T-junction models that do not take gas compressibility into consideration are not capable to simulate the exhaust gas flow with high boost pressure good enough. In order to predict pressure loss coefficients of high-pressure gas flow with higher accuracy, this paper developed a new T-junction models in which compressibility of gas flow was taken into consideration. A particle image velocimetry (PIV) test rig was established to provide data for investigating influences of flow parameters on the flow state and thermodynamic parameters in the T-junction. The results show that there are obvious streamline contractions in the internal flow field of the junction, and the formed boundary streamline divides the junction into two regions, as the flow ratio increases, the absolute value of the vorticity increases, and the vorticity in most areas of the branch joint is zero. In addition, the flow ratio of the branch pipe and the main pipe and the Mach number of the outflow affect the flow of the junction. Based on the results of the PIV test, a new pressure loss coefficient T-junction model for compressible flow is proposed. The new model has good prediction accuracy of the pressure loss coefficient and the prediction accuracy of the exhaust pressure wave increases by 4.43% when the pressure coefficient model is used in one-dimensional simulation program.

An Experimental Study Of Compressible Combining Flow At 45 Degrees T-Junctions

Experimental investigation on pressure loss of compressible combining flow at 45°T-junctions

Study on a New Pressure Loss Model of T-junction for Compressible Flow with Particle Image Velocimetry Test

Experimental Study of Solute Mixing at Double-Tee Junctions in Water Distribution Systems

Comprehensive study of combining flow conditions at pipe junctions

Experimental study on local flow resistance at junctions of circular pipes

Preliminary Experimental Study on Pressure Loss Coefficients of Exhaust Manifold Junction

Mixing at Double-Tee Junctions with Unequal Pipe Sizes in Water Distribution Systems

An Experiment-Based Comparative Investigation of Correlations for Microtube Gas Flow

Local Energy Loss at Junction of Pressurized Pipes with Rectangular Cross Section

Experimental study of the irreversible pressure loss coefficient at reduced T-junction with flat tube

Experimental study on flow rate and pressure drop characteristics in T-junction pipes under rolling conditions

PIV measurement of inner flow field in exhaust manifold junction

Experimentally Determined Solute Mixing under Laminar and Transitional Flows at Junctions in Water Distribution Systems

Local energy loss at right-angle junction of circular pipes

Experimental Investigation on the Flow Patterns in a T-junction under Steady and Rolling Motion Conditions Using PLIF

Experimental study on the flow mixing in T-junctions with an impeller

Mean Pressure Distributions on the Vanes and Flow Loss in the Branch in a T Pipe Junction with Different Angles

Numerical Simulation of Gas-Liquid Flow Through a 90° Duct Bend with a Gradual Contraction Pipe

Experimental study on pressure distributions around a circular cylinder in the branch of a t-junction

Experimental Study of Flow Structure Characteristics for a T-Junction Duct with Horizontal Vanes