Abstract:Metal matrix composite reinforced by ceramic particles generally demonstrated a significant improvement in strength, while its ductility is suppressed sharply due to the incompatible deformation between matrix and rigid reinforcements. In this work, the SiCp/2024Al composites particles have been used as deformable reinforcement, which has lower elastic modulus and considerable elongation. Three Al alloys (1050Al, 2024Al, and 7A60Al) have been used as the matrix, respectively. Compared with the uniformly distributed SiCp/Al composites with the same SiC particle amount (30 vol%), the deformable particle/2024Al composites showed comparable tensile strength and higher toughness. In-situ strain observation, fracture surface analysis, and finite element method simulation proved the main deformation mechanism in the composite shifts with the increase of matrix strength. For low-strength matrix, strain concentration occurred in the matrix, while for high-strength matrix, reinforcements could also undergo plastic deformation. It could be inferred that uneven strain distribution and stress localization could be alleviated, even avoided for composites with designed ductile reinforcement, which are crucial factors for composites' ductility and machinability. A semi-empirical model was derived from statistics to describe the strengthening behavior of the composites reinforced by deformable particles. Further discussion revealed that the optimal value of the ratio between the yield strength (YS) of reinforcement and the matrix (sigma py/ sigma my) exists, by which the strength of the composite reaches the maximum value. Accordingly, the optimal ratio could be rationalized by experiments that uniform strain distribution was observed in the deformable particle/2024Al composites.

Influence of Particle/Matrix Transition Interface on Stress Distributions in Metal Matrix Composites

Creep and Stress Relaxation Behavior of Metal Matrix Particulate Composites Induced by Interface Diffusion with Coupled Thermomechanical Strains

Microstructure-based simulation on the mechanical behavior of particle reinforced metal matrix composites with varying particle characteristics

Synergistic Interface Effects on Mechanical Properties: in Situ Study on Fracture Behaviors of Al Matrix Composite Joint

Research Progress on Interfacial Micro Structure and Properties of Particle Reinforced Metal Matrix Composites

Plastic deformation and fracture behaviors in particle-reinforced aluminum composites: A numerical approach using an enhanced finite element model

Experimental and numerical studies of the effect of particle size on the deformation behavior of the metal matrix composites

Interface Diffusion-Induced Creep in Metal Matrix Particulate Composites under Triaxial Loading

Interphase effect on the strengthening behavior of particle-reinforced metal matrix composites

Break through the strength-ductility trade-off dilemma in aluminum matrix composites via precipitation-assisted interface tailoring

Effects of Particle Size on Residual Stresses of Metal Matrix Composites

The Influence of the Volume Fraction of Ceramic Particles on the Plastic Strain Localization and Fracture of Metal Matrix Composites. Computational Analysis

A Study of Interface Damage on Mechanical Properties of Particle-Reinforced Composites

Interfacial Morphology on Mechanical Behavior of Particle Reinforced Metal Matrix Composites

The Effect of Thermal Mismatch on the Thermal Conductance of Al/SiC and Cu/diamond Composites

The Interface Structure and Property of Magnesium Matrix Composites: A Review

Mechanical Behavior of Deformable Particles Reinforced Al Matrix Composites

Elastic–plastic Stress Transfer in Short Fibre-Reinforced Metal–matrix Composites

A Study of Particle Size Effect and Interface Fracture in Aluminum Alloy Composite Via an Extended Conventional Theory of Mechanism-Based Strain-Gradient Plasticity

Multi-functional Amorphous/crystalline Interfaces Rendering Strong-and-ductile Nano-Metallic-glass/aluminum Composite

Progress in machining-induced residual stress and microstructural evolution of inhomogeneous materials and composites