Abstract:The article presents the results of an exergetic analysis of two new thermodynamic cycles: the Allam cycle and the cycle of a compressorless combined-cycle plant (the JIHT cycle). Their fundamental feature is that the carbon dioxide produced during fossil-fuel combustion can be removed directly from the power-installation cycle. Owing to this feature, such installations become extremely attractive for performing energy decarbonization. The JIHT cycle based installations are more versatile because they can be used for generating not only electricity but also heat for district heating purposes; in addition, they open the possibility to remove carbon dioxide from the cycle not in gaseous but in liquid form, which is more convenient for transportation to a consumer and/or for storage. It is shown that the electrical efficiency of an installation based on the Allam cycle makes 58.1% and that of the JIHT cycle installation operating in the cogeneration mode makes 45.5% with the total fuel efficiency equal to 92.5%. If there is no heat supply, the JIHT cycle electrical efficiency approaches that of the Allam cycle. The calculations are supported by detailed presentation of the considered cycles on a T , s diagram. The processes in which the main exergy loss occurs are highlighted. A conclusion is drawn that the installations considered can really compete with the conventional power installations with carbon dioxide capturing by means of sorption and membrane methods. To verify the procedure and computation model, an exergetic analysis was preliminarily performed for a conventional GTU-110 simple cycle gas-turbine unit, a 325 MWe combined-cycle plant (CCP) based on this unit, and a Capstone C30 microturbine with regeneration. The key scientific-technical problems that have to be solved for successfully harnessing the considered innovative cycles are highlighted. They include the development of a regenerative heat exchanger with a recovery ratio higher than 95% operating at a temperature of approximately 1000 K, an oxy–fuel combustion chamber for a pressure above 30 MPa, and a combined-cycle turbine with working fluid with an inlet temperature of higher than 1400 K and pressure above 30 MPa. These problems do not seem to be more complex than those that were set forth and successfully solved in the development of modern high-temperature high-capacity gas-turbine units.

Performance Comparison on the Evaporative Gas Turbine Cycles Combined with Different Co2-Capture Options

Simulation and Optimization of Evaporative Gas Turbine with Chemical Absorption for Carbon Dioxide Capture

Techno-economic Evaluation of the Evaporative Gas Turbine Cycle with Different CO2 Capture Options

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Design And Performance Analysis Of A Resorption Cogeneration System

Comparative Analysis on Temperature Swing Adsorption Cycle for Carbon Capture by Using Internal Heat/mass Recovery

Performance Analysis of Evaporative Biomass Air Turbine Cycle with Gasification for Topping Combustion

PERFORMANCE COMPARISON OF GAS TURBINE CYCLE COMBINED WITH SUPERCRITICAL CO2 RECOMPRESSION AND REGENERATIVE CYCLE

Innovative Ammonia Blended Natural Gas Fueled Gas Turbine − Spilt Transcritical CO2 Cycle Combined System Based on Dual-Temperature CO2 Turbines: Energy, Environmental and Economic Performance Trade-off

Influence of Gas Turbine Exhaust CO2 Concentration on the Performance of Post Combustion Carbon Capture Plant

Performance Enhancement of Gas Turbine by Supercritical CO2 Cycle Construction: System and Component Two-Level Evaluation

Thermoeconomic Analysis of a Gas Turbine and Cascaded CO2 Combined Cycle Using Thermal Oil As an Intermediate Heat-Transfer Fluid

Innovative ammonia blended natural gas fueled gas turbine − spilt transcritical CO 2 cycle combined system based on dual-temperature CO 2 turbines: Energy, environmental and economic performance trade-off

Performance analysis of selective exhaust gas recirculation integrated with fogging cooling system for gas turbine power plants

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Exergy Analysis of Part Flow Evaporative Gas Turbine Cycles: Part 1 — Introduction and Method

Comparative Analysis on Design and Off-Design Performance of Novel Cascade CO2 Combined Cycles for Gas Turbine Waste Heat Utilization

Carbon Capture Performance Assessment Applied to Combined Cycle Gas Turbine Under Part-Load Operation

A low energy consumption de-carbonization natural gas combined cycle power generation system based on LiBr/H2O absorption heat transformer

An Exergetic Analysis of New Thermodynamic Cycles Involving Carbon Dioxide Capture