Abstract:The major barriers for applying carbon dioxide (CO2) capture technology to coal-fired power plants in China and worldwide are the consequent drop in power plant energy efficiency and significantly higher cost of electricity (COE). This paper proposes a new perspective for determining the most cost-efficient CO2 capture ratio using a modeling and simulation approach that balances the per unit parasitic energy consumption for absorbent regeneration with the per unit capital cost of the CO2 capture unit of a coal-fired power plant. Using a typical 550 MW supercritical pulverized coal-fired power plant in China as the reference plant, with monoethanolamine (MEA) absorption unit for CO2 capture, a process model of the power generation unit together with the MEA CO2 capture unit was developed and detailed process simulations were conducted with the model. Then, a sensitivity analysis was then conducted to study the impact on key plant behavior indicators, including per unit energy penalty for absorbent regeneration, net power output and power generation efficiency, total capital cost of the power plant together with the MEA CO2 absorption unit, per unit capital cost of the MEA unit, COE, as well as the per unit CO2 avoidance cost (indicated by cost per tonne (t) CO2 avoided), across a CO2 capture ratio range between 20% and 99%. The results show that when CO2 capture ratio is low, while the unit energy consumption for absorbent regeneration per tCO2 avoided increases steadily with the increase of CO2 capture ratio, the cost per tCO2 avoided decreases as the MEA absorption train is scaled up given the high capital cost of each MEA train. After CO2 capture ratio reaches certain level (60% for this plant), the cost per tCO2 avoided starts to increase with CO2 capture ratio, since the unit energy consum- - ption for absorbent regeneration per tCO2 avoided has increased to so high that it supplants the scaling effect of the MEA train and becomes the dominant factor that determines the increase or decrease trend of the cost per tCO2 avoided. Besides, due to the physical restraint on the upper bound of CO2 capture capability of one single MEA train by the diameter of the absorber, an additional MEA train is needed when the CO2 capture ratio increases to certain points (40% and 85% for this plant), resulting in jumps of several parameters including the total capital cost for the power plant and MEA CO2 capture unit, per unit capital cost for the MEA CO2 capture unit, and last the cost per tCO2 avoided. Based on all these result, finally a cost-optimal CO2 capture ratio of 40% (365 RMB/tCO2-_avoided) was obtained, which is easier for the power plant to bear while realizing a significant reduction in CO2 emission of this plant. Therefore, applying this approach for determining CO2 capture ratios could help minimize the barrier for the initiation of carbon dioxide capture and storage (CCS) in China's power industry. Besides, future replacement or improvement for the MEA CO2 capture technology has the potential to further reduce the cost per tCO2 avoided, which needs special attention.

A low energy consumption de-carbonization natural gas combined cycle power generation system based on LiBr/H2O absorption heat transformer

Techno-economic Analysis on a Hybrid System with Carbon Capture and Energy Storage for Liquefied Natural Gas Cold Energy Utilization

An integrated de-carbonization supercritical coal-fired power plant incorporating a supplementary steam turbine, process heat recovery and a modified boiler structure

Post-combustion CO2 capture from a natural gas combined cycle power plant using activated carbon adsorption

Intensification, optimization and economic evaluations of the CO2-capturing oxy-combustion CO2 power system integrated with the utilization of liquefied natural gas cold energy

Industrial test of post combustion CO2 capture by reactive absorption with two new solvents in natural gas power plant

Proposal and thermodynamic investigation of pressurized calcium looping integrated with chemical looping combustion for tail-end CO 2 capture in a retrofitted natural gas combined cycle power plant

Analysis on Temperature Vacuum Swing Adsorption Integrated with Heat Pump for Efficient Carbon Capture

Performance and Cost Analysis of Natural Gas Combined Cycle Plants with Chemical Looping Combustion

Analysis of Thermally Coupled Chemical Looping Combustion-Based Power Plants with Carbon Capture

Comparative analysis of thermal economy of two SOFC-GT-ST triple hybrid power systems with carbon capture and LNG cold energy utilization

Pinch combined with exergy analysis for heat exchange network and techno-economic evaluation of coal chemical looping combustion power plant with CO<sub>2</sub> capture

Reducing initial barriers for CCS deployment on pulverized coal-fired power plants in China by optimizing the capture ratio of carbon dioxide

CO2 Capture by Using a Membrane-absorption Hybrid Process in the Nature Gas Combined Cycle Power Plants

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Co2 Mitigation in Coal Gasification Cogeneration Systems with Integration of the Shift Reaction, Co2 Absorption and Methanol Production

Analysis and optimization of post-combustion CO2capture system based on chemical absorption

Thermodynamic investigation of an integrated near-zero CO2 emission power generation system with SOFC, MGT, SCO2BC, and CO2 capture

Thermodynamic, Economic and Environmental Evaluation of an Improved Ventilation Air Methane-Based Hot Air Power Cycle Integrated with a De-Carbonization Oxy-Coal Combustion Power Plant

Techno-economic Evaluation of CO2 Capture and Storage Retrofit in Decarbonizing Different Thermal Power Plants: A Case Study in China

Performance assessment and system optimization on supercritical CO 2 double-path recompression coal-fired combined heat and power plants with MEA-based post-combustion CO 2 capture