Abstract:This work attempts to prepare ethylene-a-olefin copolymer with relatively narrow composition distribution by modification of TiCl4/MgCl2 type supported Ziegler-Natta catalyst. A TiCl4/ID/MgCl2 type catalyst, where ID is a diester, was treated at room temperature with 2,6-'Pr2C6H3-OH at phenol: Ti molar ratio of 1:1 and the modified catalyst was analyzed for contents of titanium and aryloxy group. It was found that about one third of the titanium atoms in the modified catalyst (M-cat) was connected with an aryloxy group, but its Ti content was decreased to 1.44 wt% from 2.36 wt% of the original catalyst (O-cat). Ethylene-1-hexene copolymerization was conducted in n-heptane with M-cat or O-cat as catalyst and triisobutyl aluminium or methylaluminoxane as cocatalyst. The M-cat showed similar activity as the O-cat in catalyzing the copolymerization, but presented a weaker comonomer activation effect than the latter. The 1-hexene content of copolymer synthesized by M-cat was lower than that of the product of O-cat at the same conditions, but had a markedly narrower composition distribution. Each copolymer sample was fractionated into two fractions by extraction with boiling n-heptane, and the soluble part contains much more 1-hexene units than the insoluble part. The ratio of I-hexene content in the soluble fraction to that of the insoluble fraction was higher than 18 in copolymer prepared with O-cat, but this ratio was reduced to 3.7 when M-cat was used as the catalyst. On the other hand, the soluble part of copolymer prepared with M-cat showed a more random sequence distribution than that of the O-cat. The distributions of active centers in both the M-cat and O-cat were studied by deconvolution of the polymer's molecular weight distribution curves with multiple Flory most-probable distribution function. Both catalysts showed a broad molecular weight distribution that can be ascribed to 5 similar to 6 types of active centers, but the introduction of aryloxy group in the catalyst caused marked changes in the active center distribution. Possible mechanism of the catalyst modification was proposed.

High Temperature High Pressure Tandem Polymerization of Ethylene for Synthesis of Ethylene‐1‐Hexene Copolymers from Single Reactor with SNS‐Cr and CGC‐Ti Catalysts

Tandem Action of Sns-Cr and Cgc-Ti in Preparation of Ethylene-1-Hexene Copolymers from Ethylene Feedstock

Synthesis of Ethylene‐1‐hexene Copolymers from Ethylene Stock by Tandem Action of Bis(2‐dodecylsulfanyl‐ethyl) Amine‐crcl3 and Et(Ind)2ZrCl2

Engineering Ethylene/1-Hexene Copolymers from Ethylene Stock with a Model-Guided Catalyst Feeding Policy

Effect of Catalysts Supporting on Tandem Polymerization of Ethylene Stock in Synthesis of Ethylene-1-Hexene Copolymer

Synthesis of Ultrahigh-Molecular-weight Ethylene-1-hexene Copolymers with High Hexene Content Via Living Polymerization with Fluorinated Bis(phenoxy-Imine) Titanium(iv).

Ethylene polymerization by diphenyl ether bridged dinuclear titanocenes/MAO

Modeling and Kinetics of Tandem Polymerization of Ethylene Catalyzed by Bis(2-Dodecylsulfanyl-ethyl)amine-crcl3 and Et(Ind)2ZrCl2

Ethylene polymerization with metallocene/late transition metal combined catalysts

Advanced Catalyst Technology for Broad/Bimodal Polyethylene, Achieved by Polymer-Coated Particles Supporting Hybrid Catalyst

Macromol. Rapid Commun. 3/2015

Ethylene and 1-Hexene Polymerization Using Zirconium Iminophosphonamide Complexes

ETHYLENE POLYMERIZATIONS CATALYZED BY Α-Diimine COMPLEXES WITH DIFFERENT SUBSTITUENTS ON LIGAND BACKBONE

Thermal and Mechanical Properties of Ultrahigh-Molecular-Weight Ethylene/1-Hexene Copolymers Prepared by Living Polymerization with Fluorinated Bis(Phenoxy-Imine) Titanium(Iv) Catalyst

ETHYLENE POLYMERIZATION WITH CORE-SHELL ZIEGLER-NATTA HYBRID CATALYSTS

Copolymerization of Ethylene with 1‐hexene Promoted by Novel Multi‐chelated Non‐metallocene Complexes with Imine Bridged Imidazole Ligand

Combination of 8‐aminoquinoline Nickel Dichloride and Cp2ZrCl2 Catalysts for Ethylene Polymerization

(Co)polymerization of Ethylene Via Nonmetallocene Catalysts with Diphenyl Phosphoroso Schiff‐base Ligand

Half-titanocence anilide complexes Cp′TiCl2[N(2,6-R 1 2C6H3)R2]: Synthesis, structures and catalytic properties for ethylene polymerization and copolymerization with 1-hexene

Ethylene-1-Hexene Copolymerization with A 2,6-Diisopropylphenol Modified Supported Ziegler-Natta Catalyst

With different structure ligands heterogeneous Ziegler–Natta catalysts for the preparation of copolymer of ethylene and 1-octene with high comonomer incorporation