Experimental Study on Cutting Temperature and Cutting Force in Dry Turning of Titanium Alloy Using a Non-Coated Micro-Grooved Tool

J. Xie,M. J. Luo,K. K. Wu,L. F. Yang,D. H. Li

DOI: https://doi.org/10.1016/j.ijmachtools.2013.05.006

IF: 10.331

2013-01-01

International Journal of Machine Tools and Manufacture

Abstract:Various non-coated micro-grooves with 7–149μm in depth and 0.14–0.50 in aspect ratio are proposed on tool rake surfaces along cutting chip flowing. The objective is to understand how the micro-groove shape and size influence cutting temperature and cutting force in dry turning of titanium alloy. First, the micro-grinding with a diamond wheel V-tip was employed to fabricate accurate and smooth micro-grooves; then dry turning experiments were performed with regard to material removal rate; finally, cutting temperature, cutting force and tool wear were investigated. It is shown that these micro-grooves patterned on tool rake surface contribute to decreasing cutting chip frictions and excluding cutting heat. The micro-grooved tool decreases cutting temperature by 103°C and more against traditional plane tool. The predicted cutting tip temperature reaches about 1322°C for traditional plane tool, but it does only about 500°C for micro-grooved tool. Moreover, the cutting temperature decreases and the shear angle increases with decreasing micro-groove depth except for the case of 7μm in micro-groove depth. The 25-μm-depth micro-grooved tool decreases cutting temperature and cutting force more greatly in larger material removal rate turning. In the dry turning with a micro-grooved tool, it is required that the micro-groove width is less than cutting chip width and its aspect ratio is enough large to maintain the air spaces between chip back surface and tool rake surface.