Abstract:Abstract Within a research project carried out at the Department of Civil Engineering and the Department of Mechanical Engineering of the University of Siegen, a new monitoring method for non‐destructive damage detection on bolts was developed and tested according to its applicability on real life structures. The so‐called EMI‐method is based on the measurement of electromechanical impedance spectra, which change with varying structural states and thus allow for a condition assessment. Structures vibrate in a combination of their natural modes, which can provide information about their structural condition. Their modal characteristics are system‐inherent quantities and are governed by geometry, system stiffnesses and mass allocation. If a system parameter changes, e.g. the bending stiffness of a bridge, this is reflected in the vibration analysis and the modal characteristics. To identify the modal characteristics of civil engineering structures, these are excited and the system response is measured. This principle is also used for damage detection by means of electro‐mechanical impedance spectra (EMI). The observed system‐inherent quantity is the frequency‐dependent mechanical impedance Zs(ω) of the structure. The method is based on the idea that the mechanical impedance of a structure or component to be measured changes as a result of damage (or loss of prestress in the case of bolts) and thus these changes can be detected. In the project, investigations were carried out on steel plates with orthogonally welded threaded bolts, which are used, for example, as fasteners for rail supporting points on bridges. Research objectives were on one hand the detection of the prestress stage and on the other hand the detection of fatigue damage in the weld seam. Within the scope of the project, it has been investigated to what extent a change of the prestressing load can be reliably detected by means of the EMI method. Furthermore, the influence of damage to the bolt on the impedance spectra was investigated.

Detecting the Bonding State of Explosive Welding Structures Based on EEMD and Sensitive IMF Time Entropy

A novel method for bonding state detection of explosive clad structure based on the Hilbert envelop energy ratio of mono-model signals

State Detection of Explosive Welding Structure by Dual-Tree Complex Wavelet Transform Based Permutation Entropy

Feasibility Study of Bonding State Detection of Explosive Composite Structure Based on Nonlinear Output Frequency Response Functions

Identification of bonding strength for explosive clad pipe utilizing vibration characteristics

Inhomogeneous Bonding State Modeling for Vibration Analysis of Explosive Clad Pipe

Water quality event detection based on Multivariate empirical mode decomposition

Bolt Detection Signal Analysis Method Based on ICEEMD

Mono-modal feature extraction for bonding quality detection of explosive clad structure with optimized dual-tree complex wavelet transform

The On-Line Identification and Location of Welding Interference Based on CEEMD

A Mechanical Fault Detection Strategy Based on the Doubly Iterative Empirical Mode Decomposition

Electromechanical impedance method for damage detection of typical joint on jacket platform

Analysis of acoustic emission signal in the tensile process of weld-bonding joint and its damage model

Noncontact geomagnetic defect localization of buried energy pipelines using ICEEMDAN approach with MVF

Structural modal identification through ensemble empirical modal decomposition

In Situ Disbond Detection in Adhesive Bonded Multi-Layer Metallic Joint Using Time-of-flight Variation of Guided Wave

Numerical Simulation of EMAT Signals for Detection of Debonding in HIP Welding of Multilayer Tubes

A finite element based state-space approach for vibration analysis of slender explosive clad pipe with partial contact defect

Non‐destructive damage detection on welded threaded bolts based on electromechanical impedance spectra

An Improved Time and Frequency Analysis Method Combined with WVD and EEMD

An Approach for Identifying Corrosion Damage from Acoustic Emission Signals Using Ensemble Empirical Mode Decomposition and Linear Discriminant Analysis