An Equation for Determining Methane Densities in Fluid Inclusions with Raman Shifts

Jianli Zhang,Shaohua Qiao,Wanjun Lu,Qingcheng Hu,Shuguang Chen,Yuan Liu
DOI: https://doi.org/10.1016/j.gexplo.2015.12.003
IF: 4.166
2016-01-01
Journal of Geochemical Exploration
Abstract:Raman shift of the C-H symmetric stretching band (v(1)) of methane can be used to calculate the pressure and density of methane in fluid inclusions. However, previous numerical functions for Raman band shifts and methane density are only suitable for methane with densities lower than 03 g/cm(3). In this study, Raman shifts for pure CH4 were systematically measured at 25 degrees C and pressures up to 150 MPa. Parameters of the long range attractive forces were fitted, and Raman shifts of CH4 were calculated with hard sphere model for density up to 0.55 g/cm(3). Based on experimental data and theoretical calculation, a unified equation was established to calculate the density of methane gas from Raman,shifts over a wide density ranges up to 0.55 g/cm(3):D = v(d) - v(o) = 211.3 rho(4) -73.238 rho(3) + 24.477 rho(2) -29.0632 rhowhere p represents the density of methane in g/cm(3); D(cm(-1)) is the difference between the measured peak position of methane in the fluid inclusion (v(d)) and the known peak position of methane at quite low density (v(0)). The equation will work regardless of which machine the measurements of Raman shifts are done on, as long as the user knows or finds the zero-density peak position. (C) 2015 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?