Abstract:A whole-process simulation platform is established for linear compressor to analyze the performance characteristics on different piston displacement conditions from small oscillation without pumping till to rushing out of the top dead center (TDC). The measuring methods of the related parameters in the model are presented and the values of these parameters are obtained from an actual test. The simulated results agreed well with the experimental results under the same working conditions. The errors of the effective voltage, the effective current, the compression efficiency and the phase angle between the current and the displacement were within ±6.9%, ±8.5%, ±6.2% and ±13.4%, respectively. Based on this simulation platform, the performance characteristic around the TDC of the linear compressor on different working conditions is analyzed. The performance comparison on 60 Hz shows that the compression efficiency near to the TDC on 0.7 MPa is higher than that on 0.5 MPa because the phase angle α under that condition is around 90°, but the operation reliability on 0.7 MPa is worse than that on 0.5 MPa because the jump phenomenon happens when the piston displacement goes near to the TDC. The jump phenomenon results in unstable operation as the piston displacement jumps from the position before the TDC to the position after the TDC. According to the simulation on different power frequency, two important performance characteristics are inferred. One is that there is an inflection point in the curve of the phase angle α versus the displacement at the TDC. This characteristic is a good choice for the TDC detection. The other is that the jump phenomenon is prone to happening when there exist different displacement responses on the same voltage value, becoming inconspicuous when the power frequency is decreased and disappearing when the power frequency is increased. Based on this characteristic, the jump phenomenon can be avoided through suitable system configuration and frequency adjustment.

Stroke and Natural Frequency Estimation for Linear Compressor Using Phasor Algorithm

Analytical Kinetic Model for Accurate Square-slot Stator Natural Frequency Prediction

Stroke Estimation For Linear Compressor With Energy Method

Periodic Speed Ripple Suppression Based on Cascade Filter of IPMSM Drive in Air-Conditioners

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

Study on the Stroke Amplitude of the Linear Compressor

Study on stroke unstable fluctuation of linear compressor and start-up control optimization with frequency tracking

A Sensor-Less Stroke Detection Technique for Linear Refrigeration Compressors Using Artificial Neural Network

Available pressure amplitude of linear compressor based on phasor triangle model

Performance Characteristics Around the TDC of Linear Compressor Based on Whole-Process Simulation

A novel resonant frequency tracking control for linear compressor based on MRAS method

Fuzzy logic surge control in variable speed axial compressors

Improved pulsating high-frequency voltage injection with characteristic harmonic elimination

Fourier Series Analysis Applied in Linear Compressor Vibration Analysis

Fast Efficiency Optimization Control Based on Orthogonal Current Phasor Model for Linear Oscillatory Motor

Active Surge Control for Variable Speed Axial Compressors.

Investigation of the frequency and stroke characteristics of two-stage valved linear compressor in a 4 K JT cryocooler

Power factor analysis of driving motor for linear compressor

Changing Duty Ratio PWM Control of Direct-drive Air Compressor

Research on Sensorless Vector Control for Air-conditioning Compressor

Analysis of high frequency noise sources on air conditioning variable speed compressors