Abstract:The inhomogeneous distributions of basal plane dislocations (BPDs) in PVT-grown 4H-SiC crystal boule due to internal stresses cause lattice plane bending, which strongly affect SiC-based device fabrication. The relationship between BPDs and local basal plane bending in 6-inch 4H-SiC substrates has been investigated. Synchrotron monochromatic beam x-ray topography (SMBXT) imaging shows black and white contrast of BPDs with Burgers vectors of opposite signs based on the principle of ray tracing. We have evaluated the net difference of BPDs with black and white contrast along both [112¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{2}$$\end{document}0] and [11¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{1}$$\end{document}00] radial directions on the Si face across multiple 6-inch diameter 4H-SiC substrates sliced from the same and different boules and predicted the nature (concave/convex) and amount of bending of the basal plane in these wafers. Line scans of 0008 reflection using high resolution x-ray diffractometry (HRXRD) has been carried out along the two directions to verify the nature of bending in these wafers. Results show quite different bending behavior along [112¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{2} $$\end{document}0] and [11¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{1}$$\end{document}00] directions, indicating that the Si face of 6-inch substrates creates non-isotropic bending on the basal plane. These observations are correlated quite well with net BPD density analysis. The physical shapes of the wafers were also measured to be not flat due to the surface effect. Quantitative analysis of the degree of basal plane bending based on the SMBXT data was carried out and found to be correlating well with the measured tilt angle from HRXRD. Existence of a high stress center was observed in one of the 6-inch wafers resulting in severe bending which is associated with both large bending angles and abrupt changes in lattice constants a and c.

Origin of the Warpage of 3C-Sic Wafer: Effect of Nonuniform Intrinsic Stress

Saddle‐shape Warpage of Thick 3c‐sic Wafer: Effect of Nonuniform Intrinsic Stress and Stacking Faults

Anisotropic Deformation of 4H-Sic Wafers: Insights from Nanoindentation Tests

Influence of curvature induced stress on first principle calculation and the reliability of 4H-SiC (0001) thermally grown SiO2 gate oxide

Role of the Growth Facet on the Generation and Expansion of Stacking Faults in PVT-Grown N-Type 4H-Sic Single-Crystal Boules

Influence on Curvature Induced Stress to the Flatband Voltage and Interface Density of 4H-Sic MOS Structure

In–situ strain control in epitaxial silicon carbide compound semiconductor

Stress Analysis and Optimization on Saddle-shape Warpage by Direct Patterning of Stressed Film

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Impact of Doping on Cross-Sectional Stress Assessment of 3C-SiC/Si Heteroepitaxy

Correlation between microstructure deflections and film/substrate curvature under generalized stress fields

Residual Stress Characterization of Polycrystalline 3C-Sic Films on Si(100) Deposited from Methylsilane

The Effects of Stress on Interfacial Properties and Flatband Voltage Instability of 4H-Sic MOS Structures

Optical anisotropy and strain-induced birefringence in dislocation-free silicon single crystals

Origins and characterization techniques of stress in SiC crystals: A review

Effect of Silicon-on-Insulator Substrate on Residual Strain in 3C-Sic Films

Effect of the Growth Interface Shape on the Thermoelastic Stresses in SiC Crystal Prepared by PVT Technique

Relationship Between Basal Plane Dislocation Distribution and Local Basal Plane Bending in PVT-Grown 4H-SiC Crystals

Characterization of 4H- and 6H-Like Stacking Faults in Cross Section of 3C-SiC Epitaxial Layer by Room-Temperature μ-Photoluminescence and μ-Raman Analysis

Impact of Thermal Stress on Intrinsic Point Defect in Czochralski Crystal Growth: Developing a Quantitative Model for Defect Formation and Distribution

Investigation on the Mechanism of Instability for Step Morphology During 3C-Sic (111) Vicinal Surface Epitaxial Growth