Abstract:Heat-resistant superalloys (HRSAs) exhibit excellent mechanical strength and structural stability at elevated temperatures. Hence, aerospace and power industries have consistently chosen nickel-based superalloys over the years for manufacturing hot-section components. However, poor machinability of these alloys has always been a challenge. This paper investigates the cutting performance of new-generation SiAlON ceramics under extreme conditions of dry high-speed face milling of hardened Inconel 718. Comprehensive characterization of the ceramic tool and its milling performance were conducted using instrumented micro/nano-mechanical indentations, tool life studies, optical 3D imaging, and SEM/EDS investigation of wear patterns. Also, experimental results were linked to the finite element analysis (FEA) of temperature and stress profiles. It is demonstrated that a few major factors govern the ceramic tool life under the outlined cutting conditions: (1) High temperature at the cutting edge exceeding 1250 °C. This temperature is close to the melting point of Inconel 718, and moreover, it is highly localized around the cutting edge-chip interface. (2) High resultant mechanical stress on the tool of around 5.8 GPa. (3) Thermal and mechanical fatigue loading due to the discontinuity of the milling process, combined with (4) intensive built-up edge formation caused by severe weldability of the softened workpiece to the tool. Combination of these phenomena results in a significant change in the machinability of the workpiece material after surpassing a certain limit of cutting speed. The cutting forces, tool wear, and chipping show a significant decline with increasing the speed high enough, which is attributed to the change in the material properties of the workpiece and dissolution of the hard particles within the Inconel microstructure.

Research on the Cutting Property of Ceramic Tool Cutting Nickel Based Superalloy GH4169

Wear Mechanisms and Notch Formation of Whisker-Reinforced Alumina and Sialon Ceramic Tools during High-Speed Turning of Inconel 718

Analysis on Wear Principle and Cutting Performance of Sialon Ceramic Tool in High-Speed Cutting of Superalloy Inconel 718

Cutting performance of silicon-based ceramic end milling tools in high-efficiency machining of GH4099 under dry condition

The influence of components on the high‐temperature performance and cutting performance of Si3N4‐based ceramic tools

Cutting performance and wear mechanism of spark plasma–sintered silicon nitride ceramics tool in dry turning of 41Cr4 hardened steel

Alumina ceramic tool material with enhanced properties through the addition of bionic prepared nano SiC@graphene

Analysis of tool wear and cutting characteristics in milling of powder metallurgy nickel-based superalloy by various coatings

Studies on Si3N4 Ceramic Cutting Tool Materials and Their Applications

Improvement of cutting performance of SiAlON ceramic by texture engineering in turning superalloys

Cutting performance and wear characteristics of Si3N4‐SiCw‐HfB2 ceramic cutting tools in turning of ductile cast iron

Microscopic Study on the Mechanism of Tool Bond Wear in Cutting Ni–Fe-Cr-Co–Cu Series Nickel-Base Superalloy

Influence of process parameters on the cutting performance of SiAlON ceramic tools during high-speed dry face milling of hardened Inconel 718

Geometric Structures for Sialon Ceramic Solid End Mills and Its Performance in High-Speed Milling of Nickel-Based Superalloys

Performance and wear mechanisms of coated PCBN tools in high-speed turning superalloy GH4202

Cutting performance and wear behavior of self‐developed silicon nitride ceramic end mills with optimized structure for high‐speed machining of GH4099

Ceramic Cutting Materials and Tools Suitable for Machining High-Temperature Nickel-Based Alloys: A Review

Use of ceramic tools for machining nickel based alloys

Analysis of Tool Wear in GH4169 Material Milling Process

Comparative study on NiAl and FeAl intermetallic-bonded diamond tools and grinding performance for Si3N4 ceramic

Roughing Milling with Ceramic Tools in Comparison with Sintered Carbide on Nickel-Based Alloys