Abstract:With the aim of enhancing the understanding of the complex dynamics of deep drilling, an integrated model with complex time delays and Stribeck friction is presented for studies on the axial-torsional dynamics of a drill string. Various aspects of the drill string are considered, including spatial distribution, structural and external damping, dry friction-induced damping, boundary conditions, and complex bit-rock interactions. The drill-string structure is spatially discretized by using the finite element method. With the resulting discretized complex delay system, stability analysis is conducted following the semi-discretization procedure. Through parametric studies, the effects of drilling parameters, dry friction, boundary conditions, and rock-strength properties on the drilling stability are obtained. Subsequently, an optimally tuned boundary condition with compliance is deployed at the top drive to expand the stable region and mitigate self-excited vibrations in the operational parameter space of drilling. To find the distribution of stress along the drill string, numerical simulations are conducted. The dynamical stress caused by self-excited vibrations is illustrated in the spatial–temporal plane. Strain and stress analysis reveal wave propagation along the drill string, including traveling and standing waves. The dynamic effective stress along the drill string is studied, and the von Mises effective stress is determined by combining the axial stress and torsional stress. On the basis of this information, the locations of the vulnerable points along the drill string are found in terms of structural strength. Finally, the tuned boundary condition at the top is deployed in the numerical simulations to show vibration control effectiveness. The results point to two possible vibration-cancellation approaches that can benefit from a tuned top boundary. The findings of this work can serve as a basis for identifying the locations of vulnerable points and alleviating the levels of axial-torsional vibrations in drilling applications.

Coupled Axial-Torsional Dynamics in Rotary Drilling with State-Dependent Delay: Stability and Control

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Dynamic Modeling and Trajectory Tracking Control of a Novel Muck-Removal Hydraulic Manipulator

Drill-string stability and stress localization: Influence of complex delay effects and dry friction

Backstepping sliding mode control of stabilized platform for fully rotary steerable drilling system based on nonlinear disturbance observer

Drilling Control System Using an Equivalent Input Disturbance-Based Control With a Neutral-Type Axial-Torsional Coupled Dynamics Model

Observer-Based Adaptive Sliding Mode Compensation Position-Tracking Control for Drilling Tool Attitude Adjustment

Dynamics Analysis Control on Dual Delay Bearing-Rotor System

Self-Stabilizing Control Strategy of Stabilized Platform for Rotary Steerable Drilling System Based on Adaptive Backstepping Control

Mechanism Analysis on Torsional Stick-slip Vibration of Drillstring in Extended Reach Well and Some Ways to Its Suppression

Exponential Lyapunov Stability Analysis of a Drilling Mechanism

Control of a 3D Piezo-Actuating Table by Using an Adaptive Sliding-Mode Controller for a Drilling Process.

An Alternative Formulation for Modeling Self-Excited Vibrations of Drillstring With PDC Bits

Control of a slender rotary system subjected to dry friction and rub

An Optimal Active-disturbance-rejection Controller for the Rotary Speed of An Anchor-hole Drill Based on Brain Storm Optimization Algorithm

Dynamic modeling and load transfer prediction of drill-string axial vibration in horizontal well drilling

Practical Stability Analysis of a Drilling Pipe Under Friction With a PI-Controller

Nonlinear dynamics investigation of a multi-axis drive system due to the kinematic joints

Prediction and Computer Simulation of Dynamic Thrust and Torque in Vibration Drilling

Nonlinear characteristic and chip breaking mechanism for an axial low-frequency self-excited vibration drilling robot

Computational modeling of the nonlinear stochastic dynamics of horizontal drillstrings