Abstract:Downhole vibration, such as backward or chaotic whirling, is one of the primary causes for drill string failure during drilling operation. Understanding drilling dynamics is crucial for determining the mechanism of vibration and fatigue accumulation so as to mitigate risk of drill string failure. Drilling dynamics or vibration data can either be obtained from real-time measurement or simulation based on dynamics model, which plays a crucial role for drilling optimization in pre-drill planning phase. An advanced 4D drilling dynamics model, which considers the interaction between drill bit and formation, impact and friction between drill string and wellbore, constraints exerted on drill string and drill bit, is proposed to simulate the distribution and variation of 3D displacement, velocity, acceleration as well as the stress state of entire drill string within specified time period. This time domain model allows exploration of the full range of dynamics response under different drilling scenarios, which helps to optimize the performance and reliability of BHA as well as WOB/RPM selection. Moreover, drill string fatigue life prediction can also be achieved by combing simulated stress state and fatigue accumulation theory. Simulation shows that BHA with smaller- sized drill collar or fewer stabilizers are more susceptible to backward and even chaotic whirling while drilling. Also, inappropriate WOB/RPM combinations such as low WOB with high RPM could also cause the onset of severe lateral vibration. High frequency bending stress, mainly concentrated on BHA and caused by lateral vibration, is the main reason for rapid fatigue accumulation and continuous severe vibration could even result in drill string fatigue failure within hours. These findings helped to justify the 5 consecutive BHA failure and 1 washout while drilling the 171/2" wellbore with 7621 ft length of an ultra-deep well. Simulation also showed that downhole lateral vibration severity was significantly reduced after optimizing drill bit design, adopting BHA with larger stiffness and optimizing drilling parameters, which guaranteed the successful drilling of a new 171/2" wellbore with 4659 ft length of another offset well without downhole accident. This 4D drilling dynamics model could be used to conduct comparative analysis of dynamics responses based on specific criteria to identify the optimum BHA design and drilling parameters, which shows great potential in drill string fatigue failure prevention and drilling optimization.

Prediction and Computer Simulation of Dynamic Thrust and Torque in Vibration Drilling

A Theoretical and Experimental Investigation of Thrust and Torque in Vibration Microdrilling

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Dynamic modeling and load transfer prediction of drill-string axial vibration in horizontal well drilling

Drilling force model for forced low frequency vibration assisted drilling of Ti-6Al-4V titanium alloy

Study on dynamic drilling forces of CFRP/Ti stacks during longitudinal-torsional ultrasonic vibration drilling

Dynamic modelling and simulation of peripheral milling process

Modeling and experimental investigation of drilling force for low-frequency axial vibration-assisted BTA deep hole drilling

Mechanical model for predicting thrust force with tool wear effects in drilling of unidirectional CFRP

Prediction model optimization and experimental verification based on the material characteristic and dynamic angle on thrust force and torque in drilling GJV450

A Multibody Dynamic Model of Drillstring for Torque and Drag Analysis

A Theoretical Dynamic Model to Study the Vibration Response Characteristics of an Axial Piston Pump

Dynamic modeling and vibration prediction of an industrial robot in manufacturing

A multibody dynamic model of the drilling system with drilling fluid

A Mathematical Model for Predicting Cutting Force in Rotary Ultrasonic Drilling

Nonlinear dynamic modeling and vibration analysis of whole machine tool

Efficient and High-Fidelity Steering Ability Prediction of a Slender Drilling Assembly

Dynamic simulation and active vibration control design of an ultra-precision fly-cutting machine tool

Modeling and experimental analysis of ultrasonic vibration drilling force prediction model for tiny small holes in high body fraction aluminum-based silicon carbide composites

Advanced 4D Drilling Dynamics Model Simulates Downhole Vibration and Helps to Optimize in Preventing Drill String Failure