Abstract:The low heat conduction values and high mechanical properties of stainless steels, which have high resistance to corrosion, make them difficult to be machined. Custom 450, a martensitic stainless steel alloy, is highly resistant to corrosion especially at high temperatures and is used in ammunition coolant tanks. Although there are studies on the machinability of stainless steel alloys in the literature, studies on the drillability of Custom 450 martensitic stainless steel are quite limited. For this reason, Custom 450 material was subjected to drilling experiments in the study with 4 different cutting speeds and 4 different feed rates using 4 different carbide drill bits without using coolant. In order to model and minimize the thrust force, drill bit temperature and burr height values, experiments and measurements were carried out using the L16 orthogonal arrays of Taguchi method. Drilling variables were optimized simultaneously by applying Taguchi-based Grey Relational Analysis (GRA) with the help of the data obtained from the experiments. Mathematical models have been developed by using the Response Surface Method (RSM) in order to predict the experimental results. It was observed that there was a significant increase in the thrust forces and burr heights with increasing values of the feed rate. The drill bit temperature was adversely affected by the increasing values of cutting speed. According to the analysis of variance, it was seen that the most effective control factors were 86.30% feed rate for thrust force, 97.52% cutting speed for temperature and 85.87% for burr height. Following the GRA, the feed rate was found to be the most important control factor with a value of 0.2921. Moreover, according to the results of multiple response optimizations, the most suitable parameters were identified as 15 m/min. Cutting speed, 0.005 mm/rev feed rate, and the drill bit number 4. The reliability of the developed mathematical model was confirmed with determination coefficients which are 98.34% for thrust forces, 99.78% for drill bit temperature and 98.54% for burr height.

Prediction model optimization and experimental verification based on the material characteristic and dynamic angle on thrust force and torque in drilling GJV450

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

A New Calculation Model of Cutterhead Torque and Investigation of Its Influencing Factors

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Prediction and Computer Simulation of Dynamic Thrust and Torque in Vibration Drilling

Drilling force model for forced low frequency vibration assisted drilling of Ti-6Al-4V titanium alloy

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Modeling and Optimization of High-Grade Compacted Graphite Iron Milling Force and Surface Roughness Via Response Surface Methodology

Mechanical model for predicting thrust force with tool wear effects in drilling of unidirectional CFRP

A Theoretical and Experimental Investigation of Thrust and Torque in Vibration Microdrilling

A prediction model of drilling force in CFRP internal chip removal hole drilling based on support vector regression

Tool wear monitoring in drilling of high-strength compacted graphite cast irons

Physics-Based Predictive Cutting Force Model in Ultrasonic-Vibration-Assisted Grinding for Titanium Drilling

Turning processes and mechanism of compacted graphite iron used for high performance engine

Dynamic modeling and load transfer prediction of drill-string axial vibration in horizontal well drilling

Force modeling of vertical surface grinding considering wheel-workpiece contact geometry

Investigation of force modeling in ultrasonic vibration-assisted drilling SiC f /SiC ceramic matrix composites

Modelling and Optimization for Thrust Force, Temperature and Burr Height in Drilling of Custom 450

Modeling and experimental analysis of ultrasonic vibration drilling force prediction model for tiny small holes in high body fraction aluminum-based silicon carbide composites

Modeling and Optimization of Dynamic Performances of Large-Scale Lead Screws Whirl Milling with Multi-Point Variable Constraints