Abstract:Isostructural alloying has been regarded as an important approach to boosting thermoelectric performance of narrow gap semiconductors through thermal conductivity reduction. However, it does harm to carrier mobilities as well because of atomic disorders. Here, we extend the alloying concept from "isostructural" to "quasi-isostructural", which means that the two alloying components are no longer strictly isostructural but structurally closely related. As a proof-of-concept, a series of cubic Cu2SnSe3–tetragonal Cu3SbSe4 quasi-isostructural alloys (Cu2+xSn1–xSbxSe3+x) were synthesized, and their thermoelectric transport properties were systematically studied. No significant loss of carrier mobilities was found during quasi-isostructural alloying, probably due to the structural similarity of the two end members as well as the negligible mass contrasts between Sn and Sb. Surprisingly, a remarkable reduction of lattice thermal conductivity from 1.2 W m–1 K–1 for Cu2SnSe3/Cu3SbSe4 to 0.4 W m–1 K–1 for Cu5SnSbSe7 at 673 K was observed, which can hardly be explained from a solid solution perspective. Our X-ray photoelectron spectroscopy analysis unambiguously demonstrate the coexistence of Sn2+ and Sn4+ in the alloying systems, whereas Sn simply exhibits Sn4+ in Cu2SnSe3. We deduce that the minute structural changes of Cu2SnSe3 during quasi-isostructural alloying make Sn discordant, leading to its valence state splitting. The mixed-valence scattering therefore strongly impedes phonon propagation beyond alloying. Altogether, a considerably enhanced ZT ≈ 0.4 is realized in the sample with x = 0.2, which is 150% improvement over the x = 0 sample. By selecting the x = 0.5 sample as a representative, a preliminary doping study was performed but seems unsuccessful because of the varying Sn2+/Sn4+ ratio. We expect higher thermoelectric performance in those quasi-isostructural alloys if their carrier concentration can be fully optimized.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.1c01155?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.1c01155</a>.Temperature-dependent heat capacity (Cp), thermal diffusivities (D) and Lorenz number (L) for Cu2+xSn1–xSbxSe3+x (x = 0, 0.2, 0.5, 0.8, and 1.0). The longitudinal (νl) and transverse (νt) acoustic velocities, calculation of average acoustic velocity (vs) (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.1c01155/suppl_file/ae1c01155_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

A First-Principles Theoretical Study on the Thermoelectric Properties of the Compound Cu5alsn2s8

Toward Ultrahigh Thermoelectric Performance of Cu2SnS3‐Based Materials by Analog Alloying

Enhanced Thermoelectric Properties of Earth-Abundant Cu2sns3 Via in Doping Effect

Towards a new chalcopyrite high-performance thermoelectric semiconductor Cu3InSnSe5 by entropy engineering

CuAlTe$_2$: A promising bulk thermoelectric material

Enhanced Stability and Thermoelectric Performance in Cu 1.85 Se-Based Compounds

Eco-friendly P-Type Cu2SnS3 Thermoelectric Material: Crystal Structure and Transport Properties

The comprehensive first-principle study of the thermoelectric performance of p- and n-type SnS

Theoretical Investigation on Thermoelectric Properties of Cu-Based Chalcopyrite Compounds

Quasi-isostructural Alloying of Cu 2 SnSe 3 –Cu 3 SbSe 4 toward Higher Thermoelectric Performance

First-principles study of anisotropic thermoelectric transport properties of IV-VI semiconductor compounds SnSe and SnS

Realizing the Ultralow Lattice Thermal Conductivity of Cu3SbSe4 Compound via Sulfur Alloying Effect

Approaching high thermoelectric performance in p-type Cu3SbS4-based materials by rational electronic and nano/microstructural engineering

Doping Achieves High Thermoelectric Performance in SnS: A First-Principles Study

Thermoelectric Properties of Doped-Cu3SbSe4 Compounds: A First-Principles Insight

Superconductivity in efficient thermoelectric Cu$_3$Sb$_{0.98}$Al$_{0.02}$Se$_4$

Atomic-scale structure and thermoelectric properties in medium-entropy PbSnTeSe alloy

Cu$_2$ZnSiTe$_4$: A potential thermoelectric material with promising electronic transport

First-principles prediction of extraordinary thermoelectric efficiency in superionic Li2SnX3(X=S,Se)

First-principles investigation on the thermoelectric performance of half-Heusler compound CuLiX(X = Se, Te)

Weak-Bonding Elements Lead to High Thermoelectric Performance in BaSnS 3 and SrSnS 3 : A First-Principles Study