Abstract:A capillary pumped loop is a two-phase heat transfer device which has been increasingly applied in thermal control of satellite or spacecraft and electronic cooling. However, startup performance of a normal capillary pumped loop is poor and hydrodynamic oscillation in the system appears sometime during its operation. A flat-plate-type capillary pumped loop is constructed and tested in the present study, which combines the advantages of a capillary pumped loop and a loop heat pipe by improving both system and components. In the present capillary pumped loop, both evaporator and condenser are designed as a type of flat plate with porous wick, and a reservoir is used to control and adjust operation temperature of the system. In addition, a subcooler is adopted to improve the quality of working fluid flowing back to the evaporator. A plane type of evaporator with a cross channel for the liquid supply was made to reduce the probability of a dry-out point caused by strong evaporation in the case of high heat flux, and therefore to enhance the stability of the system. Also, a plane type of condenser with a porous wick is designed, which is of the three ports for vapor-pipe inlet, liquid-pipe outlet, and an adjusting pipe connected to a reservoir. The startup performance of the system benefits greatly from this three-port design, as liquid in the system can be easily pressed into a reservoir due to resistance reduction. The performance of a capillary pumped loop prototype was tested in startup, persistence operations, and different vacuum. Startup experiments under different heat loads and working conditions were conducted. Excellent startup performance, being stable and easy, has been shown for the plane-type capillary pumped loop system, which validates the new configuration. Pressure oscillation and temperature fluctuation in the system were reduced largely owing to the induction of a porous wick in the plane condenser. During experimental processes lasting more than 10 h, the new type capillary pumped loop shows outstanding thermal behavior and no dry-out phenomena were observed. The testing results indicate that 1) the new capillary pumped loop system shows excellent startup performance without pressure priming and liquid clearing of vapor line; and 2) the new capillary pumped loop system is stable under very severe operational conditions, such as low load, sudden power step, etc.

Experimental investigation of pump-assisted capillary phase change loop

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Performance characteristics of a two-phase pump-assisted loop heat pipe with dual-evaporators in parallel

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Experimental Investigation Of New Flat-Plate-Type Capillary Pumped Loop

Effect of liquid charging process on the operational characteristics of pump-assisted capillary phase change loop

Startup Characteristics of Pump-Assisted Capillary Phase Change Loop

Experimental study of mechanical-capillary driven phase-change loop for heat dissipation of electronic devices and batteries

A Study on Thermal Performance of a Pump-Assisted Loop Heat Pipe with Ammonia As Working Fluid

Simulation of heat and mass transfer process in a flat-plate loop heat pipe and experimental comparison

Experimental Study of a Novel Loop Heat Pipe with a Vapor-Driven Jet Injector and a Boiling Pool

Experimental Study on A Flat Loop Heat Pipe Coupling the Compensation Chamber and the Condenser

Phase change driving mechanism and model for Capillary Pumped Loop and Loop Heat Pipe

Experimental Study of Heat Transfer Capacity for Loop Heat Pipe with Flat Disk Evaporator

Experimental investigation of two-phase thermosyphon loop for passive containment cooling

Experimental Study on the Dynamic Heat Transfer Characteristics of a Mechanically Pumped Two-phase Cooling Loop

Experimental investigation on a mechanically pumped two-phase cooling loop with dual-evaporator

Experimental study on the thermal performance of a novel two-phase loop thermosyphon under low-heat-flux conditions

Experimental Investigation of a Dual Compensation Chamber Loop Heat Pipe

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Design and Performance Test of Miniature Capillary Pumped Loop for Electronics Cooling