Abstract:Inefficient performance of CO2 refrigerant in hot climates has become a major obstacle to its wide application in electric vehicles. In this paper, the vacant heating core in cooling mode was exploited to increase the heat transfer area of evaporator and improve system performance. With the aid of a validated evaporator model and an experimental test rig, performance improvements brought by this added area were evaluated. Results indicated that this area is not suggested to be directly added to cooling core. This necessitates a dual-evaporator (D-E) configuration. For case I (small CO2 pressure drop), the growth rate in heat transfer rate brought by D-E configuration is 19∼20% and less sensitive to parallel or series operation. Nevertheless, this growth rate for case II (large CO2 pressure drop) is greatly affected, 30.6∼32.6% for parallel operation and 7.5∼17.6% for series operation. Specifically, it is around 17.5% and 7.5∼13.6% for series cross-parallel and cross-counter arrangements, respectively. By comprehensive consideration, the cross-parallel arrangement is recommended to be adopted. Experimental results indicated that the cross-parallel D-E configuration greatly increases the evaporation temperature and exhibits a slight impact on optimum high pressure within the transcritical cycle. The enhancement in COP brought by this configuration is around 6∼12% without additional cost, and it rises with the decreased air flowrate through evaporator and air velocity through gas cooler and the increased ambient temperature. This indicates that this configuration is an effective and economical technology to alleviate the efficiency degradation issue of transcritical CO2 automotive air-conditioners.

New approach to improve performance by venting periodic reverse vapor flow in microchannel evaporator

Effect of venting the periodic reverse vapor flow on the performance of a microchannel evaporator in air-conditioning systems

Evaporator Performance Enhancement by Pulsation Width Modulation (PWM)

The new refrigeration system with vortex tube and ejector

Periodic Reverse Flow and Boiling Fluctuations in A Microchannel Evaporator of an R134a Mobile Air-Conditioning System

Performance Analysis of a Novel Hybrid Vapor Injection Cycle with Subcooler and Flash Tank for Air-Source Heat Pumps

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Performance Analysis of a New Ejector Enhanced Vapor Injection Heat Pump Cycle

Study on the Performance of a Novel Waste Heat Recovery System at Low Temperatures

Periodical reverse flow and boiling fluctuations in a microchannel evaporator of an air-conditioning system

Comparative Studies of Ejector-Expansion Vapor Compression Refrigeration Cycles for Applications in Domestic Refrigerator-Freezers

Experimental study on refrigerant maldistribution in a fin-and-tube evaporator for a direct expansion air-conditioning system

Flash Gas Bypass in Mobile Air Conditioning System with R134a

Investigating performance of new mini-channel evaporators

Visualization and measurement of periodic reverse flow and boiling fluctuations in a microchannel evaporator of an air-conditioning system

Effect of the header pressure drop induced flow maldistribution on the microchannel evaporator performance

Effectiveness of actively adjusting vapour-liquid in the evaporator for heat transfer enhancement

Simulation Study on the Performance of a Vapor-Bypassed Evaporator for Heat Pump Applications

Numerical simulation of flow distribution characteristics in carbon dioxide microchannel evaporator

Research progress on optimizing two-phase refrigerant distribution and boiling heat transfer in microchannel evaporators

Energetic performance evaluation of an automotive CO2 air conditioning system with a dual-evaporator configuration