Abstract:The relationship among raw materials used, processing conditions, the resulting morphology, and mechanical properties were studied for unidirectional (1D), bidirectional (D) and tridirectional (3D) carbon-carbon composites. Experimental results demonstrated that an increased number of densifications and higher composite densities were associated with elevated strength properties. Generally, tensile and flexural properties were found to be fiber-dominated, whereas compression behavior was mainly affected by density and matrix morphologies. Tensile moduli of 1D and 3D composites were found to be higher than values calculated according to the fibers' content. This was attributed to the contribution of the sheath matrix morphology. Tensile strength levels were significantly lower than expected because of residual stresses resulting from thermal processing. With respect to matrix effects, measured properties indicated that high glass-like carbon fraction resulted in enhanced strength and modulus, both in tension and compression. Microstructure observations indicated that higher matrix packing density contributed to this result. Pitches containing heavy fractions gave rise to increased compression strength, whereas light fraction types of pitches displayed higher tensile strength, because of different matrix morphologies in each case. Atmospheric pressure carbonization of 3D composites resulted in void-containing matrix with almost no sheath morphology. Consequently, the associated mechanical properties were inferior. Distinctively, atmospheric pressure carbonization of 1D and 2D composites is quite effective in sheath morphology formation. Consequently, mechanical properties are only slightly inferior to those of the high-pressure densified composites. Finally, it was observed that graphitization tended to reduce strength and enhance modulus, compared to only carbonized composites. Non-sequentially graphitized 3D composites are disadvantageous, compared with composites graphitized following each densification. The duration of graphitization tended to reduce compression strength with longer processes.

Investigation on Mechanical Properties of Porous Fiber Bundle-Matrix Interlayers in Three-Dimensional Carbon/Carbon Composite

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Mechanical and interfacial analysis of 3D-printed two-matrix continuous carbon fibre composites for enhanced structural performance

Micro-CT Characterization on the Meso-Structure of Three-Dimensional Full Five-Directional Braided Composite

An investigation into mechanical properties of a 3D printed two-matrix continuous fiber composites with multi-cavity structure

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Preparation, microstructure and properties of three-dimensional carbon/carbon composites withhigh thermal conductivity

Effect of materials and processing on the mechanical properties of C/C composites

Layout design and mechanical behavior of 3D printed intralayer hybrid continuous carbon/glass fiber composites

Effect of preform structure on mechanical and thermal properties of SiCf/SiC composites

Examination of voids and geometry of bio-based braided composite structures

Characteristics of interfaces in 3D fine weave carbon/carbon composites

Study on mechanical properties and thermal conductivity of 3D short carbon fiber reinforced ultra-high temperature ceramic matrix composites: A novel material performance evaluation model

Investigation on the mechanical properties of 3D printed hybrid continuous fiber-filled composite considering influence of interfaces

Pore-throat structure characterization of carbon fiber reinforced resin matrix composites: Employing Micro-CT and Avizo technique

Evaluation of porosity effects on the mechanical properties of carbon fiber-reinforced plastic unidirectional laminates by X-ray computed tomography and mechanical testing

Mechanical and thermal conduction properties of carbon/carbon composites with different carbon matrix microstructures

Investigations of three-dimensional fiber orientation on mechanical impact behavior of short glass-fiber-reinforced PEEK composites

Comparative studies on the effect of fabric structure on mechanical properties of carbon fiber/epoxy composites

Advances in Multiscale Modeling and Mechanical Properties Characterization of 3D‐Braided Composites

Investigation of the mechanical and forming behaviour of 3D warp interlock carbon woven fabrics for complex shape of composite material