Abstract:An elastoviscoplastic constitutive equation is proposed to describe both the elastic and rate-dependent plastic deformation behavior of Carbopol® dispersions, commonly used to study yield-stress fluids. The model, a variant of the nonlinear Maxwell model with stress-dependent relaxation time, eliminates the need for a separate Herschel–Bulkley yield stress. The stress dependence of the viscosity was determined experimentally by evaluating the steady-state flow stress at a constant applied shear rate and by measuring the steady-state creep rate at constant applied shear stress. Experimentally, the viscosity’s stress-dependence was confirmed to follow the Ree–Eyring model. Furthermore, it is shown that the Carbopol® dispersions used here obey time-stress superposition, indicating that all relaxation times experience the same stress dependence. This was demonstrated by building a compliance mastercurve using horizontal shifting on a logarithmic time axis of creep curves measured at different stress levels and by constructing mastercurves of the storage- and loss-modulus curves determined independently by orthogonal superposition measurements at different applied constant shear stresses. Overall, the key feature of the proposed constitutive equation is its incorporation of a nonlinear stress-activated change in relaxation time, which enables a smooth transition from elastic to viscous behavior during start-up flow experiments. This approach bypasses the need for a distinct Herschel–Bulkley yield stress as a separate material characteristic. Additionally, the model successfully replicates the observed steady-state flow stress in transient-flow scenarios and the steady-state flow rate in creep experiments, underlining its effectiveness in capturing the material’s dynamic response. Finally, the one-dimensional description is readily extended to a full three-dimensional finite-strain elastoviscoplastic constitutive equation.

New analysis of yield stress on giant electrorheological fluids

Ultrahigh Yield Stress in a General Electrorheological Fluid under Compression

MECHANISM OF THE GIANT ELECTRORHEOLOGICAL EFFECT

Formation of Polarized Contact Layers and the Giant Electrorheological Effect

The Giant Electrorheological Effect in Suspensions of Nanoparticles

Compressions of Electrorheological Fluids under Different Initial Gap Distances

Study on additive in electrorheological fluid

Structure factor of electrorheological fluids in compressive flow

Electrorheological Fluid under Elongation, Compression, and Shearing.

Enhancing yield stress of electrorheological fluids with liquid crystal additive

On the Apparent Yield Stress in Non-Brownian Magnetorheological Fluids

Saturated orientational polarization of polar molecules in giant electrorheological fluids.

No yield stress required: Stress-activated flow in simple yield-stress fluids

ELONGATION COMPRESSION AND SHEARING CHARACTERISTICS OF ER FLUIDS UNDER ELECTRIC FIELDS

Internal microstructures in shearing giant electrorheological fluids

Normalized Method for Comparing Tensile Behaviors of Electrorheological Fluids

Squeeze flow viscoelasticity of electrorheological fluids based on microcrystalline cellulose

Electrorheological Effects at High Shear Rate

Compression Enhanced Shear Yield Stress of Electrorheological Fluid

Strain shift measured from stress-controlled oscillatory shear: Evidence for a continuous yielding transition and new techniques to determine recovery rheology measures

Conductivity Effect in Electrorheological Fluids