Onset and Departure of Flow Boiling Heat Transfer Characteristics of Cyclohexane in a Horizontal Minichannel

Zhaohui Liu,Qincheng Bi
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2015.04.088
IF: 5.2
2015-01-01
International Journal of Heat and Mass Transfer
Abstract:The flow boiling behavior of cyclohexane was experimentally investigated in a horizontal minichannel with inner diameter of 2.0 mm. The nucleation hysteresis phenomena at onset of nucleate boing (ONB) and characteristics at departure of flow boiling were focused on. Both the temperature overshoot due to nucleation hysteresis and wall superheat to maintain boiling conditions decreased with the increasing pressure. The nucleation hysteresis can be clearly observed at pressure of (1.0 and 2.0) MPa, but disappeared at 3.0 MPa. A wall temperature decrease phenomenon (TDP) was found to occur just before flow boiling heat transfer deterioration (HTD). The magnitudes of TOP would be less than 10 degrees C, but bigger than the temperature overshoot of about 3 degrees C at ONB. Wherever HTD happened at the saturation boiling conditions with high or low vapor quality ranging from 0 to 1, the TOP were observed, but suppressed by the increasing pressure. Accordant with nucleate hysteresis, the TDP were clearly recorded at P = 1.0 and 2.0 MPa, but disappeared at 3.0 MPa. The mechanism of TOP before HTD at flow boiling condition, a problem needed extensive focus investigation, may give a better understanding or even a universe CHF mechanism for both dryout and burnout conditions. (C) 2015 Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?