Abstract:The particle size and pore size of spherical mesoporous silica materials play significant roles in their application. However, relatively limited systematic research has been conducted on how preparation conditions influence these properties. In particular, the effects of some important factors have not been adequately studied, including reaction time, reaction temperature, and organic solvent type. In this work, octane and water were used as solvents, and tetraethyl orthosilicate was used as the silicon source to systematically study the effects of reaction time, reaction temperature, different organic solvents, octane/water mass ratio, styrene template concentration, and surfactant (cetyltrimethylammonium bromide, CTAB)/H2O mass ratio on the particle morphology, particle size, and pore size of silica. The results suggest that the above-mentioned neglected factors exert a substantial influence on both particle size and pore size. In the experimental temperature range, the pore diameter decreases and the particle size increases with increasing temperature. The maximum particle size and pore size are achieved after a reaction time of 3 h, and a further increase in reaction time leads to a smaller particle size and pore size. As the number of carbon atoms in the organic solvent decreases, the pore size also gradually increases. Styrene and organic solvents that dissolve in CTAB micelles are crucial factors in pore formation, while the aggregation of the swollen CTAB micelles influences the particle size. The changes in the pore structure stability and hydroxyl density of the synthesized samples in water were also studied. After undergoing water treatment at temperatures ranging from 20 to 60 °C for 72 h, both the pore structure and morphology remain relatively unchanged. When the temperature increases, the surface hydroxyl density exhibits a more pronounced increase in the presence of water. After water treatment for 5 h, the surface hydroxyl density reaches saturation.

Effect of the drying process on the preparation of porous silica microspheres

Preparation of Methyltrimethoxysilane Derived Silica Aerogel Films via Ambient Pressure Drying

Effects of Precipitation and Drying Processes on the Synthesis of Silica Materials with A Large-Pore-Volume and Narrow-Pore-Diameter Distribution

Influence of Drying Procedure on the Mesoporosity and Surface Fractal Dimensions of Silica Xerogels Prepared with Different Agitation Methods

Drying of Hierarchically Organized Porous Silica Monoliths-Comparison of Evaporative and Supercritical Drying

Role of Hydrophobic Attraction and Hydrophobic Nanoconfined Channels in the Spray Drying Process for Synthesizing Hollow Microspheres from Silica Sol

Preparation of Silica Material with High Pore Volume by Precipitation in Membrane Dispersion Reactor

Effects of Surfactants on the Synthesis of Silica Aerogels Prepared by Ambient Pressure Drying

Effects of different parameters on the synthesis of silica aerogel microspheres in supercritical CO2 and their potential use as an adsorbent

Effects of synthesis conditions on particle size and pore size of spherical mesoporous silica

Preparation of highly dispersed nanosilica from rice husk by aprecipitation method combined with high pressure homogenization

Preparation of silica microspheres with bimodal pore structure in micro-channel

On the improvement of pore accessibility through post-synthesis hydrothermal treatments of spray dried SBA-15 microspheres

Preparation of silica micro spheres via a semibatch sol–gel method

Seclusion: uses and complications.

[Specific DNA recognition by Myb protein].

A One-Step Ultrasonic Spray Pyrolysis Approach to Large-Scale Synthesis of Silica Microspheres

Micrometer‐sized Monodispersed Silica Spheres with Advanced Adsorption Properties

Preparation of hundred-micron carbon spheres using solvent extraction in a simple microchannel device

Formation of Uniform Large Sba-15 Microspheres Via Spray Drying

Preparation of Homogeneous Super-Circular Alumina Microspheres in Microchannels by Controlling Extraction and Motion Processes