Abstract:The oxidation of bond coat (BC) and interdiffusion between BC layer and superalloys were two mechanisms that contribute to the degradation of thermal barrier coating system (TBCs). The oxidation and interdiffusion of TBCs on single-crystal superalloys were comparatively studied in this work at 950 °C, 1050 °C and 1100 °C over a duration of 1500 h. The results indicated that the thickness of the thermally grown oxide (TGO) progressively increased with the oxidation time and temperature, following a parabolic law. The discontinuous TGO gradually developed into a double-layer structure: the upper layer was a mixed oxide layer, while the lower layer predominantly comprises an Al 2 O 3 layer. Moreover, an interdiffusion zone (IDZ) is formed at the interface between the BC layer and the substrate, with its thickness increasing in response to both temperature and oxidation time. The Cr-rich phases appeared in the IDZ, where Al initially diffused from the BC layer to the substrate, followed by a reverse diffusion process. Simultaneously, Ni and refractory elements diffused from the substrate into IDZ, resulting in the precipitation of the topologically close-packed (TCP) phases and the formation of a secondary reaction zone (SRZ). It has further been shown that Cr-rich phases further diffused into SRZ. Higher oxidation temperatures accelerated the growth of the SRZ and facilitated the transformation of the TCP phases from a blocky to a needle-like morphology. Ultimately, the continuous growth of IDZ and SRZ led to the evolution of the substrate from a monocrystalline to a polycrystalline structure. This study provides valuable data on the microstructural evolution of TBCs and the assessment of their service life.

EPMA and TEM characterization of intergranular tellurium corrosion of Ni–16Mo–7Cr–4Fe superalloy

Intermetallic compounds Cr3Te4/NiNbTe2 formation during infiltrating Te into Inconel 718

Effect of μ precipitation and γ′ evolution on intra/intergranular strength of Ni-Co-Cr-based superalloys after 800 °C thermal exposure

Effect of Different Water Toughening Treatment on Mechanical Properties and Microstructure of Fe-Mn-C TWIP Steel

Microstructure and mechanical properties of a new Ni–Co based superalloy at intermediate temperatures

Effect of Yttrium on Intergranular Embrittlement Behavior of GH3535 Alloy Induced by Tellurium

Effect of element Te on alterations of microstructure and mechanical property of nickel-based superalloy Inconel 718 through alloy infiltration

Microstructural characterization of the η-Ni<sub>3</sub>(Ti, Al) phase in a long-term-aged Ni-based superalloy

Enhancement of Te infiltration into Inconel 718 surface layer through dynamic microwave thermal shock

Effect of Cr on the Microstructure and Oxidation Properties of Co-Al-W Superalloys Studied by in Situ Environmental TEM

Microstructure and Elevated Temperature Tensile Behaviour of Directionally Solidified Nickel Based Superalloy

Interdiffusion Behavior and Compositional Tailoring of AlCoCrFeNiY High-Entropy Alloy Coating on a Hastelloy-X Superalloy

Effect of alloying elements (Mn, Ti, and Mo) on the corrosion behavior of FeCoNiCr-based high entropy alloy in supercritical water

Characterization of microstructure, grain distribution, and tribocorrosion properties of NiTi-based alloy

Effect of Mn addition on the tellurium embrittlement resistance of GH3535 alloy

Intergranular Corrosion of an Al-Cu-Li Alloy: the Influence from Grain Structure

A study on the resistance to tellurium diffusion of MCrAlY coating prepared by arc ion plating on a Ni-16Mo-7Cr alloy

Comparative study of temperature-dependent oxidation and interdiffusion behavior on NiCoCrAlYHf-coated nickel-based single-crystal superalloys

Microstructural Evolution and Mechanical Properties of a Ni-Based Superalloy, TMW-4

Microstructural Characterization of the Η-Ni3(ti, Al) Phase in a Long-Term-aged Ni-based Superalloy

Microstructural characteristics, deformation behavior and mechanical properties of Inconel 718 treated by Te infiltration