Abstract:Dysprosium barium copper oxide – bismuth sodium titanate ((1- x )DyBCO− x BNT) ceramics, where x = 0−0.07 mole fraction, were successfully prepared by a solid-state reaction and sintering method. The DyBa 2 Cu 3 O 7-δ and (Bi 0.5 Na 0.5 )TiO 3 powders were separately synthesized by calcining their stoichiometric mixtures at 900°C for 4 h and 800°C for 2 h, respectively. The (1- x )DyBCO− x BNT powders were compacted into pellets and sintered at 930°C for 2 h under normal air atmosphere. Phase identification and morphology of all samples were determined using X-ray diffractometer (XRD). The quantitative phase analysis was analyzed by fitting the XRD pattern using the GSAS-II program. Scanning electron microscopy (SEM) with energy dispersive X-ray spectroscopy (EDS) was used to study microstructure and chemical composition. In all cases, the result of XRD shows that the DyBa 2 Cu 3 O 7–δ (Dy-123) was identified as the main crystalline phases, due to the good agreement between the observed and calculated patterns after Rietveld refinement. All BNT-doped DyBCO ceramics showed slightly higher density values than the undoped sample, suggesting that BNT helped improve the densification process. The sign of the Seebeck coefficient ( S ) was positive for all samples at all measured temperatures, confirming a p-type conduction mechanism. Low BNT doping improved the overall thermoelectric properties of DyBCO ceramics by affecting electrical conductivity ( σ ), Seebeck coefficient ( S ), and thermal conductivity ( κ ). The dimensionless figure of merit ( ZT=S2σT/κ ) of all samples increased with increasing temperature. The highest ZT value of 5.67 × 10 −2 was observed for the 0.97DyBCO−0.03BNT sample at 863 K.

High Temperature Thermoelectric Properties of Dy-doped CaMnO3 Ceramics

High‐Temperature Thermoelectric Behaviors of Fine‐Grained Gd‐Doped CaMnO3 Ceramics

High-temperature Electrical Transport Behaviors in Textured Ca3Co4O9-based Polycrystalline Ceramics

High-Temperature Electric Properties of Polycrystalline La-Doped Camno3 Ceramics

Thermoelectric properties of CaMnO3 ceramics produced by using powder synthesized by modified Pechini method

High thermoelectric performance of Nb-doped SrTiO3 bulk materials with different doping levels

Structure, Magnetic, Electrical and Thermal Transport Properties of Dy-doped Ca3Co2O6 Ceramics

High-Temperature Thermoelectric Behaviors of Sn-Doped N-Type Bi2o2se Ceramics

Enhanced Thermoelectric Performance of Heavy-Metals (M: Ba, Pb) Doped Misfit-Layered Ceramics: (ca2−xmxcoo3)0.62 (Coo2)

Thermoelectric properties of Ca3-xYxCo4O9+δ ceramics

High-Temperature Electrical Transport and Thermoelectric Power of Partially Substituted Ca<sub>3</sub>Co<sub>4</sub>O<sub>9</sub>-Based Ceramics

Synthesis and high thermal stability of Mn doped Y2/3Cu3Ti4O12 negative temperature coefficient ceramic

Electro-Thermo-Magnetic Effect-Induced Large Thermoelectric Performance of Calcium Cobaltite Nanocomposites

Effect of perovskite template seeds on microstructures and thermoelectric properties of Ca0.87Ag0.1Dy0.03MnO3 ceramics

High Temperature Thermoelectric Properties of Oxide Ca2co2o5

High-Temperature Electrical Transport Behaviors of the Layered Ca2co2o5-Based Ceramics

High-temperature Thermoelectric Properties of Ca0.9−xSrxYb0.1MnO3−δ (≤X≤0.2)

Lead-Free Mnte Mid-Temperature Thermoelectric Materials: Facile Synthesis, P-Type Doping And Transport Properties

Dielectric Properties of Pure and Mn-doped CaCu3Ti4O12 Ceramics over a Wide Temperature Range

High-temperature thermoelectric properties of (1-x)DyBCO − xBNT ceramics

Investigation of electron and phonon transport in Bi-doped CaMnO$_3$ for thermoelectric applications