Abstract:Organic photovoltaic solar cells can offer advantages of being mechanically flexible and durable, large area devices, lightweight, made from a diversity of materials and low-cost fabrication. Their efficiency is, however, still too low for commercial exploitation. Empirical observations reveal that polymer–fullerene (P3HT:PCBM) based solar cell performance depends on thermal annealing processes employed, especially the annealing temperatures and durations. The annealing parameters are known to influence the energetics and kinetics of the blending process or morphology, but the associated physics is not fully understood. In this work, current density–voltage characteristics of P3HT:PCBM bulk heterojunction organic solar cells, thermally annealed at different temperatures, 65–160 °C post fabrication, were investigated under dark and illuminated conditions, and compared to their as-cast counterparts. In certain electrical regimes, as-cast devices showed higher values of current density in comparison to the corresponding annealed devices. Such performance was attributed to air-borne chemical doping of the as-cast semiconductor layer, which creates electrically conductive percolation pathways within the as-cast devices. We propose that annealing of semiconductors must be a two-step process, which first initiates decrease in conductivity, followed by its increase. As-cast devices P3HT–PCBM bulk heterojunction solar cells prepared under atmospheric conditions were observed to have comparatively superior photovoltaic performance in comparison to thermally annealed devices. The efficiency drop in the annealed counterparts is attributed to dedoping due to thermal annealing. An annealing temperature of ~ 140 °C was found to be optimum for power conversion efficiency in the bulk heterojunction, 1:1 by mass, P3HT:PCBM based solar cells.

Impact of solar irradiance intensity and temperature on the performance of compensated crystalline silicon solar cells

Influence of the Compensation Level on the Performance of P-Type Crystalline Silicon Solar Cells: Theoretical Calculations and Experimental Study

Effect of Dopant Compensation on the Performance of Czochralski Silicon Solar Cells

Study on Permanent Deactivation of the Light-Induced Degradation in P-Type Compensated Crystalline Silicon Solar Cells

Reassessment of silicon heterojunction cell performance under operating conditions

Analysis of the Photovoltaic Properties of N-Type Compensated Silicon Solar Cells with the Al-Alloyed Emitter

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Determination of the Boron and Phosphorus Ionization Energies in Compensated Silicon by Temperature-Dependent Luminescence

EFFECT OF VARIABLE TEMPERATURE PHOSPHOROUS GETTERING TREATMENTS ON THE PERFORMANCE OF MULTICRYSTALLINE SILICON

Silicon Nanocrystal Conjugated Polymer Hybrid Solar Cells with Improved Performance

Photovoltaic Output Parameters Of A Mono-Crystalline Silicon Solar Cell With Non-Uniform Horizontal Temperature Distributions

Kinetics of light and elevated temperature-induced degradation in cast mono p-type silicon

Effect of Temperature on Performance Parameters of Metallurgical Grade Polysilicon Solar Cells

The Effect and Mechanism of Current Injection to Suppress Light and Elevated Temperature Induced Degradation in P-Type Cast-Mono and Multicrystalline Silicon Passivated Emitter and Rear Cells

Temperature-dependent Performance of Amorphous Silicon Photovoltaic/thermal Systems in the Long Term Operation

The Effect Of Non-Uniform Illumination On The Performance Of Conventional Polycrystalline Silicon Solar Cell

Effects on Amorphous Silicon Photovoltaic Performance from High-temperature Annealing Pulses in Photovoltaic Thermal Hybrid Devices

Potential-induced Degradation: Recombination Behavior, Temperature Coefficients and Mismatch Losses in Crystalline Silicon Photovoltaic Power Plant

Heat generation and mitigation in silicon solar cells and modules

Effect of Temperature on Ideality Factor for PERC Monofacial Crystalline Silicon Solar Module

EFFECT OF TEMPERATURE ON PERFORMANCE PARAMETERS OF MULTICRYSTALLINE SILICON SOLAR CELLS AND MODULES