Abstract:Cost-effective and environmentally friendly sorbents were created for capturing CO 2 by incorporating monoethanolamine (MEA) and tetraethylenepentamine (TEPA) onto a microporous activated carbon (AC) material. The application of a KOH reagent enhanced the surface area and pore volume of the carbon material. The BET, SEM, EDX, and FTIR techniques were employed to analyze the structural and surface properties of the developed samples. Raw AC possessed the highest surface area and largest micropore volume equal to 786 m 2 /g and 0.33 cm 3 /g, respectively. The amine impregnation increased the nitrogen content of the carbon material, but it also significantly reduced the BET surface area and total pore volume, which are primarily responsible for physically adsorbing CO 2 towards ACs. The CO 2 adsorption performance of the raw and impregnated ACs was experimentally evaluated using thermogravimetric analysis (TGA) at different adsorption temperatures (25 and 50 °C) and CO 2 concentrations (10 and 90 vol.%). The findings demonstrated that the raw AC exhibited the highest capacity for CO 2 adsorption. Specifically, at a temperature of 25 °C and pressure of 1 bar (10 vol.% CO 2 , N 2 balance), the raw AC achieved an uptake of 1.2 mmol/g, which was 60.3% and 79.3% higher compared to the CO 2 uptake of MEA-AC (0.5 mmol/g) and TEPA-AC (0.3 mmol/g), respectively. It is surprising that the combined uptake of CO 2 + H 2 O increased by 12.5 and 23.4 wt.% (equivalent to 7 and 13 mmol/g) for MEA-AC and TEPA-AC, respectively, when humid flue gas was taken into account under the conditions of 50 °C, with 10 vol.% CO 2 , 4 vol.% H 2 O, and N 2 balance. These results indicate that the presence of H 2 O facilitates the chemisorption of CO 2 by the novel and highly promising carbon-based sorbent prepared in this study, leading to an increased capacity for adsorbing CO 2 under water vapor containing flue gases.

Adsorption of H2o and Co2 on Supported Amine Sorbents

Preparation and Co2 Sorption/Desorption of N-(3-Aminopropyl) Aminoethyl Tributylphosphonium Amino Acid Salt Ionic Liquids Supported into Porous Silica Particles

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Evaluation of CO2/H2O Co-Adsorption Models for the Anion Exchange Resin Lewatit VPOC 1065 under Direct Air Capture Conditions Using a Novel Lab Setup

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Carbon dioxide capture by functionalized solid amine sorbents with simulated flue gas conditions.

Hydrophobic functionalized amine-impregnated resin for CO2 capture in humid air

CO2/H2O adsorption and co-adsorption on functionalized and modified mesoporous silicas

Impact of H2O on CO2 adsorption and co-adsorption: Mechanism and high-performance adsorbents for efficient H2O-CO2 capture

CO2 Adsorption by Polyamine-Based Protic Ionic Liquid-Functionalized Mesoporous Silica: Regenerability and Influence of Flue Gas Contaminants

Adsorption of Wet Dilute Carbon Dioxide on an Amine-Based Resin Sorbent: Static and Dynamic Experiments

Investigation of Thermal Stability and Continuous CO2 Capture from Flue Gases with Supported Amine Sorbent

Continuous CO2 Capture in Dual Fluidized Beds Using Silica Supported Amine

Effect of Amine Surface Coverage on the Co-Adsorption of CO2 and Water: Spectral Deconvolution of Adsorbed Species

Solid Sorbents as a Retrofit Technology for CO2 Removal from Natural Gas Under High Pressure and Temperature Conditions

Facile fabrication of mesoporosity silica as support for solid amine CO2 adsorbents with enhanced adsorption capacity and kinetics

The effect of humidity on the enhanced CO2 adsorption of amine-functionalized microporous activated carbon

Amine-impregnated Alumina Solid Sorbents for CO2 Capture. Lessons Learned

Study on the Roles of Water in Solid Amine-Based Direct Air Capture of CO2

Post-Combustion CO2 Capture Demonstration Using Supported Amine Sorbents: Design and Evaluation of 200 Kwth Pilot

Application of Polyethylenimine‐impregnated Solid Adsorbents for Direct Capture of Low‐concentration CO2