Tube Hydro-Forging − a Method to Manufacture Hollow Component with Varied Cross-Section Perimeters
Guan-Nan Chu,Gang Chen,Yan-Li Lin,Shi-Jian Yuan
DOI: https://doi.org/10.1016/j.jmatprotec.2017.11.007
IF: 6.3
2017-01-01
Journal of Materials Processing Technology
Abstract:To overcome the problems in high pressure tube hydroforming (HPTH), such as too high forming pressure, thickness thinning and low productivity, a new forming technology was put forward, named as tube hydro-forging(THFG). In THFG, hollow components were formed by cross-section compression, overturned the traditional idea about conventional tube hydroforming in which the tube was expanded into the desired shape. Compared with HPTH, the role of the internal pressure was translated into the function of supporting and the tube sidewall was subjected to compression deformation throughout the process. These changes permit the THFG process with lots of advantages, such as low required internal pressure, avoiding thickness thinning or crack defect, no need for axial feeding, and so on. In this study, an analytical model based on a rigid, perfectly plastic material model was developed to investigate the possibility and the main influencing factors of the THFG. The analytical solution developed was compared with the experimental results. Experimental results validate that the tube can be formed into the desired shape by cross-section compression under a certain internal pressure supporting. Through the analytical model combining FEM simulation, the critical support pressure was given. The critical support pressure increases gradually as the deformation going on and has great dependence on the materials properties, however has no dependence on the tube thickness. It is also validated that the required pressure in the THFG is much lower than that needed in the traditional tube hydroforming.