Abstract:To progress toward the high efficiency and low emission aviation engine technology, it is mandatory to understand the complex phenomena including kerosene spray atomization, evaporation, turbulent mixing and combustion in the engine combustor. Nowadays with the rapid growth of computational capacity over the world, large-eddy simulation (LES) performs a more and more important role in understanding the complex multi-phase combustion process of kerosene fuels in aviation engine configuration. In the present work, LES is employed to investigate a swirling kerosene spray jet flame in a model combustor, which has been studied experimentally. The turbulent combustion is modeled by the flamelet generated manifold (FGM) approach with a 3-component surrogate kerosene skeletal mechanism. The averaged gas velocity and temperature predicted by LES generally agrees well with the experimental measurements. Local extinction is observed at the inner shear layer of the swirling spray flame, due to droplet-turbulence-flame interactions. A parametric study with 11 cases is then performed to investigate the effects of inlet swirl/Reynolds number and fuel heating value on the kerosene flame. As the swirl number increases, the enhanced turbulent mixing between kerosene fuel and air facilitates the combustion process, but combustion instabilities may occur if the swirl number is too high. A higher Reynolds number can promote the turbulent combustion via a stronger recirculation zone, but it also has strong dilution effects on the combustion field. Variations in the fuel heating value directly impact the temperature field, but the flow field, major species concentrations and droplet phase statistics are only slightly affected. These LES results give clues to achieve optimal combustion performance in realistic aviation engine configurations via better arrangements of fuel and air injections.

Influences of Angles of Attack and Sideslip on the Flow Field of a Cantilevered Ramp Injector in Supersonic Flows

Parametric study on mixing augmentation mechanism induced by cantilevered ramp injectors in a shock-induced combustion ramjet engine

Effects of Ramp-Induced Incident Shock Impingement Under Various Slope Angle Configurations in a Strut-Based/Cavity-Assisted Supersonic Combustor

Computational Study of the Effect of Dual Air Swirling Injection on Turbulent Combustion of Kerosene–Air at a High Pressure

Effects of Staged Injection on Supersonic Mixing and Combustion

Experimental investigation of flow field features and spark ignition process in a multi-swirl airblast injector

Improvement of Mixing Efficiency in the Combustion Chamber of a Powder-Fuel Ramjet Engine

Investigation of strut-ramp injector in a Scramjet combustor: effect of strut geometry, fuel and jet diameter on mixing characteristics

Numerical Simulation of Shock-Induced-Combustion in Three-Dimensional HyShot Scramjet Model

Influence of the non-equal aligned nozzles for fuel injection inside the supersonic combustion chamber

Computational modeling of the rectangular non-aligned multi-injector for efficient fuel mixing in a supersonic combustion chamber

Swirling flow and spray atomization interactions in a swirl cup airblast fuel injector: Outer swirler effect

Optimization and Data Mining for Shock-Induced Mixing Enhancement inside Scramjet Using Stochastic Deep-Learning Flowfield Prediction

The role of annular 2-lobe nozzle in a strut injection system on the mechanism of fuel distribution at a scramjet engine

Combustion performance of an evaporative flameholder under subsonic-supersonic mixing inflow

Investigation on compression ramp with surface V-groove for scramjet combustor

Numerical Investigation on Mechanism of Swirling Flow of the Prefilming Air-Blast Fuel Injector

Effects of inflow velocity on transverse jet injection in a supersonic cavity combustor

Influence of the secondary flow control on the transverse gaseous injection flow field properties in a supersonic flow

Effects of lifted fuel injection using an upstream ramp of a cavity on scramjet combustion

Large-eddy Simulation Investigation on the Effects of Inlet Swirl/reynolds Number and Fuel Heating Value on a Turbulent Kerosene Spray Flame