Abstract:Interfacial strength of carbon fiber modified by two nanomaterials ZnO nanowires and nickel‐based metal–organic framework (MOF) are studied using single fiber indentation studies. The interfacial shear strength of ZnO and MOF‐modified fibers higher than as‐is fibers by 9–17%. A capillary flow‐based model is developed to explain the resin penetration through nanoscale features. Enhancing fiber surfaces through in situ growth of nanomaterials is known to improve fiber composite properties by enhancing the interface between the fiber and matrix. In this study, hydrothermal processes are used to achieve two types of interfacial modification for carbon fiber: zinc oxide nanowires (ZnO NWs) and nickel‐based metal–organic frameworks (MOF). The interfacial strengths are evaluated using single fiber push‐in tests via nanoindentation and the interfaces are analyzed through dynamic modulus‐mapping. It is found that ZnO modification increases the interface strength by 9.40%, while MOF modification yields an even higher improvement of 16.34%. The load‐displacement plots exhibit distinctive inflection points, elucidated through microstructural observations. Examining the modulus map of the interface region, a transition in the storage modulus from the fiber to the matrix is identified. A capillary flow‐based model is developed to explain the resin penetration through nanoscale features. The findings reported here indicate that the timescale for resin absorption is significantly shorter than the curing timescales for the surface modifications explored in this study.

Mode-I Pullout Model of Nanofibers with Surface Effects

Pullout Strength of Graphene and Carbon Nanotube/epoxy Composites

Keynote: EXPLICIT MODELLING OF FIBRE PULLOUT IN CEMENTITIOUS COMPOSITES

Enhancement of pullout energy in a single-walled carbon nanotube-polyethylene composite system via auxetic effect

Dynamic Tensile Behavior of Fiber Reinforced Materials Based on Fiber Layering Modeling

AN INTERFACIAL PULLOUT MODEL FOR HOOKED FIBER IN CEMENTITIOUS MATERIALS

Influence of Interfacial Microstructure on Pullout Behavior and Failure Mechanism of Steel Fibers Embedded in Cement-Based Materials

Properties of Frictional Bridging in Fiber Pull-out for Fiber-Reinforced Composites

Coulomb frictional interfacial stresstransfer in fiber pull-out

A Pull-out Equivalent Telescopic Layered Failure Model of Carbon Fiber Bundles in Seawater Sea-Sand Cementitious Matrix

An experimental and numerical study on the age depended bond-slip behavior between nano-silica modified carbon fibers and cementitious matrices

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

Adhesion Model of Side Contact for an Extensible Elastic Fiber

A New Model of Interfacial Adhesive Strength of Fiber-Reinforced Polymeric Composites Upon Consideration of Cohesive Force

A Dynamic Meso-Scale Model of the Pullout Behavior for Non-Straight Fibers and Corresponding DEM3 Simulation

A pullout model for inclined carbon nanotube

A Unified Model for Fibers With Divergent Pullout Behaviors in Strain Hardening Cementitious Composites (SHCC)

Effect of Nanoscale Surface Modification on the Interfacial Mechanics of Carbon Fibers

The Effects of Thermal Residual Stresses and Interfacial Properties on the Transverse Behaviors of Fiber Composites with Different Microstructures

Hygrothermal Effects on Initial Frictional Pull-Out Force of CNTs-Reinforced Composites

Effect of the water/cement ratio on the improvement of pullout behaviors using nano-SiO2 modified steel fiber and the micro mechanism