Abstract:A356 alloy was widely used in automobile industry due to its excellent castability and comprehensive mechanical properties. But, with increasing demands of strictly safety of components, fatigue life of A356 alloy became the key properties which were considered seriously. To evaluate the time-consuming properties, elongation, as a replaced property, was employed for its easy testing and the relationship which was proportional to the fatigue life of materials. Semi-solid processing was proved that it can improve the elongation of materials while the mechanical properties still kept at the same level as original alloy. Presently, many semi-solid techniques were developed to produce various products, in which the additional equipment was necessary to form the semi-solid microstructure. Therefore, this work is aimed to development an easily technique to obtain the semi-solid microstructure. In present study, A356 alloy with typical semi-solid microstructure was obtained by addition of RE elements during melt processing. In addition, the melting and pouring process was kept the same as the normal gravity casting of A356 alloy. After the treatment, the elongation was 19.5% for A356 alloy with RE addition, which was much higher than that of 13% for normal A356 alloy. Microstructure observation showed that the morphology of Si was changed significantly, and the shape of spheroid was dominantly appeared other than short rod shape. The improvement of elongation was attributed to the morphology change of α-Al and eutectic Si.

A New Technology to Improve the Elongation of A356 Alloy

Enhanced Strength and Ductility of A356 Alloy Due to Composite Effect of Near-Rapid Solidification and Thermo-Mechanical Treatment

In-situ Study of Microstructure and Mechanical Properties of GH3536 Alloy Manufactured by Selective Laser Melting at 750 °C

The Effect of Initial Microstructure of A356 Alloys on the Mechanical Behavior in the Semisolid State

Effect Of Dynamic Composite Refinement And Modification On Microstructure Of A356 Aluminum Alloy

A356 Alloy Refined by Melt Thermal Treatment

Experimental Studies on Rheocasting Processing of A356 Alloy

Effect of Solutionising and Ageing on the Microstructure and Mechanical Properties of a High Strength Die-Cast Al–Mg–Zn–Si Alloy

Microstructure and Mechanical Properties of A356 Aluminum Alloy Prepared by Casting Combined with Back Extrusion

New technique for preparing A356 alloy semisolid slurry and its rheo-diecast microstructure and properties

Rheologic Properties of Aluminum Alloy A356 Bille ts Produced by Semisolid Continuous Casting Process

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Optimizing the Mechanical Performance of A356-Sc-Sr Alloy Via Combining Machine Learning and Mechanical Stirring under Vacuum

A New Strategy for a Combination of Permanent Magnet Stirring and La–Ce Addition Toward the Solidification of A356 Aluminum Alloy

Effect of Melt Mixing Refining and Modification Treatment on Microstructure of A356 Aluminum Alloy

Effects of Al-Ti-B-RE + Al-10Sr Master Alloys on Refinement and Modification Performances of A356 Alloy

The Influences of the Microstructure Morphology of A356 Alloy on Its Rheological Behavior in the Semi-Solid State

Influence of Al-Ti-B Addition on the Microstructure and Mechanical Properties of A356 Alloys

Enhanced comprehensive performance via alloying and rheo-diecasting in a semi-solid Al–Si–Fe–Mg–Cu–Sr alloy

Effect of Al-Sr-Y intermediate alloy on microstructure and mechanical properties of A356 alloy

Effect of Mass Fraction of Mischmetal Addition on Microstructures of A356 Alloy