Abstract:This paper presents the results of a study on removal of Pb 2+ ions by using hydroxyapatite (HAP) scaffold prepared by replication method. To this aim, the effects of suspension solid content and polymeric foam density on the properties of ceramic foam were investigated. The mean total porosity and apparent porosity of the optimized scaffolds were 92.67 % and 92.04 %, respectively. The Taguchi method was performed for designing batch experiments by considering three controllable variables, namely: (1) initial pH of the solution, (2) initial concentration of Pb 2+ ions (C 0 ), and (3) circulating rate of the solution (Ǭ), on the removal efficiency of Pb 2+ ions as the response. Based on the obtained results from the ANOVA analysis, the removal efficiency of Pb 2+ ions was mainly affected by the initial pH of the solution (90.88 %). The highest removal efficiency (99.1 %) of Pb 2+ ions was obtained by optimizing the process under operating conditions of pH = 3.5, C 0 = 50 mg.L −1 , and Ǭ= 0.5 L.min −1 . The Langmuir isotherm model with good accuracy was fitted to the equilibrium results, and the maximum adsorption capacity of 106.38 mg.g −1 was predicted for the HAP scaffold adsorbent. Kinetic studies showed that the mass transfer diffusion steps in the external film and inside the pores are fast, being the adsorption on the adsorbent sites the rate-limiting step of the kinetics, what is plausible given the high porosity of the material. Also, the primary mechanism for Pb 2+ adsorption using HAP scaffold adsorbents was found to be dissolution-precipitation. The fixed-bed column adsorption experiments performed under the predicted optimum conditions of batch experiments. In comparison to the powder adsorbents tested in fixed-bed column, this adsorbent presents several advantages. These include the elimination of the requirement for mechanical separation of the shaped adsorbent from the solution after adsorption, prevention of bed clogging, and its high surface area derived from interconnected open pores.

Optimizing production of hydroxyapatite from alkaline residue for removal of Pb 2+ from wastewater

Adsorption of Pb (II) Ions onto Hydroxyapatite Nanopowders in Aqueous Solutions

Preparation of Porous Hydroxyapatite Using Cetyl Trimethyl Ammonium Bromide as Surfactant for the Removal of Lead Ions from Aquatic Solutions

Strontium-doped hydroxyapatite as adsorbent effectively to remove lead ions from water

Performance of oxalate-doped hydroxyapatite as well as relative contribution of oxalate and phosphate for aqueous lead removal

Optimization of Hydrothermal Synthesis of Hydroxyapatite from Chicken Eggshell Waste for Effective Adsorption of Aqueous Pb(II)

Recycling of biogenic hydroxyapatite (HAP) for cleaning of lead from wastewater: performance and mechanism

Optimization of Pb(II) ions adsorption on nanohydroxyapatite adsorbents by applying Taguchi method

Removal of Pb(II) from aqueous solution using hydroxyapatite/calcium silicate hydrate (HAP/C-S-H) composite adsorbent prepared by a phosphate recovery process

Conversion of Waste FGD Gypsum into Hydroxyapatite for Removal of Pb2+ and Cd2+ from Wastewater

A facile microwave-assisted synthesis of mesoporous hydroxyapatite as an efficient adsorbent for Pb2+ adsorption

Exploratory of immobilization remediation of hydroxyapatite (HAP) on lead-contaminated soils

Synthesis of Rod-Like Hydroxyapatite with High Surface Area and Pore Volume from Eggshells for Effective Adsorption of Aqueous Pb(II)

Nano-hydroxyapatite-assisted enzyme-induced carbonate precipitation enhances Pb-contaminated aqueous solution and loess remediation

Surface and mass transfer kinetic and equilibrium modeling of Pb(II) ions adsorption on hydroxyapatite scaffold: Batch and fixed-bed column studies

Synthesis and physicochemical evaluation of hydroxyapatite gel biosorbent for toxic Pb(II) removal from wastewater

Comparing the effects of humic acid and oxalic acid on Pb(II) immobilization by a green synthesized nanocrystalline hydroxyapatite

Efficient Removal of Pb(II) from Aqueous Solution by Using an Exothermic Padding Waste Derived Magnetic Adsorbent

Zirconium Phosphonate Doped Pva/Chitosan Hybrid Gel Beads for Enhanced Selective Extraction of Pb2+ from Water

Effective Removal of Pb <sup>2+</sup> from Aqueous Solution Using FO/MS Prepared by Rubidium-Containing Biotite Leaching Residues and Leaching Wastewater

Preparation of RIR/PAA Hydrogel and the Removal of Pb2+ from Wastewater