Abstract:Packaging materials have a great impact on the performance and reliability of light-emitting diodes (LEDs). In this study, we have prepared high performance LED devices through encapsulating LEDs by epoxy materials incorporated with filler powders. A set of evaluation methods have also been established to characterize the reliability of LED devices. No delamination or internal cracking between packaging materials and lead frames has been found for the encapsulated high performance LED devices after the package saturation with moisture and subsequent exposure to high-temperature solder reflow and thermal cycling. Four kinds of inorganic silica fillers, namely, quartz, fused silica, cristobalite, and spherical silica, and one kind of organic filler, that is, spherical silicone powder, were incorporated into the epoxy packaging materials to compare their effects on performance of LED devices. The properties of epoxy packaging materials and LED devices were studied by differential scanning calorimetry (DSC), thermogravimetric analyses (TGA), dynamic mechanical analysis (DMA), thermomechanical analyzer (TMA), ultravioletvisible spectrophotometer (UV-vis), scanning acoustic microscopy (SAM), and scanning electron microscopy (SEM). Except the spherical silicone powder filled epoxy materials, all the other filled systems showed lower equilibrium water sorption content and smaller water diffusion coefficient in both water sorption and moisture sorption tests. The coefficient of thermal expansion (CTE) values were also decreased with the addition of fillers, and the systems filled with quartz, fused, and filled with spherical silica gave the best performance, which exhibited the reduced CTE values both below and above Tg. The results of TGA essentially showed no difference between filled and unfilled systems. The glass transition temperature changed little for all the filled systems, except the one incorporated with spherical silicone. The modulus at room temperature increased with the addition of fillers. The light transmittance of filled epoxy materials varied with fillers after UV and thermal aging.

Led Package with Dome/Side-Emitting-Enhancement Silicone Lens Achieved by Dispensing and Geometry Transferring

Polymer Dispensing and Embossing Technology for the Lens Type LED Packaging

Optical Design in Packaging and Illuminating System for High Power Light-Emitting Diodes for Projection System

A Novel Process Obtaining Silicone Dome Lens for Wafer Level LED Packaging

Freeform Lens Design for LED Illmination

High-performance Light-Emitting Diodes Encapsulated with Silica-Filled Epoxy Materials.

Design of Optical Structure for Chip-on-board Wafer Level Packaging LEDs

Epoxy Molding Compound Lead Frames With Silicone Resin for Encapsulating AlGaN-Based UVB Light-Emitting Diodes

Optimized Design of LED Freeform Lens for Uniform Circular Illumination

Silicon based wafer-level packaging for flip-chip LEDs

A Cost Effective Process for Large Area Photonic Array Applied in Light Emitting Diodes for Light Extraction Enhancement

Designs on Flip-Glass of LED Package for Selective Enhancement of Emitting-Intensity and View-Angle

A sandwich structure of multi-chip COB LED with double flat glass boards coated with phosphors film by screen printing technique

53.2: An Optimization Design Method of LED Freeform Lens for Uniform Circular Illumination

‘Flip Glass Substrate’ Package Technology for LED Yield and Performance Enhancement

Side-Emitting LED with Conical and Parabolic Reflector and Its Application in LCD Backlight

Enhancing Optical Performance of Chip-Scale Packaged White LEDs by Phosphor-in-Glass With High-Reflective Dam

Light-emitting diode spherical packages: an equation for the light transmission efficiency

Zno Quantum Dots-Filled Encapsulant for Led Packaging

High Refractive Index and Transparency Nanocomposites As Encapsulant for High Brightness Led Packaging

Enhanced Light Extraction Efficiency of an LED Package by a Surface-Mounted Amorphous Photonic Structure