Abstract:Simulation of full wave, without paraxial approximation, high-resolution solution of wave equations in frequency domain in the electron cyclotron resonance (ECR) frequency range for realistic Tokamak plasma parameters became possible by using recently formulated hybrid iterative algorithm [Svidzinski et al., Phys. Plasmas 25, 082509 (2018)] for numerically solving discretized wave equations. This approach combines time evolution and iterative relaxation techniques into iteration cycles. This algorithm is implemented in 2D code FullWave, solving wave equations in Tokamaks in cold and hot plasma models, and it has been tested in 3D full wave iterative RF beams simulation tool, which is presently being developed to model 3D ECRH RF beams in fusion devices using dynamic grid adaptation. The results of 2D full wave modeling, assuming specified toroidal mode number, of ECRH RF beams in DIII-D plasma, performed in the cold and hot plasma models for outboard and top launch scenarios using FullWave are presented. Nonlocal hot plasma response model, based on accurate numerical solution of linearized Vlasov equation, is used to model beam propagation and absorption in the 2nd electron cyclotron harmonic region. Demonstration of capability of the hybrid iterative algorithm to model ECRH RF beams in 3D is made by simulating a substantial part of realistic beam in DIII-D, launched from outboard side of the machine. All relevant physics of RF beam propagation, most of which is not captured in paraxial approximation, such as beam's divergence, interference between the X and O modes in the beam, X-O mode conversion, beam splitting into the X and O mode beams, transformation of beam's cross section, and absorption at the 2nd electron cyclotron harmonic, is captured in the simulations. A numerical technique to find an optimal beam polarization at the launcher to launch a nearly pure X or O mode beam in plasma is developed and tested.

Two-Dimensional Hybrid Model for High-Current Electron Beam Transport in A Dense Plasma

Three-Dimensional Pic-Mc Modeling for Relativistic Electron Beam Transport Through Dense Plasma

PIC-MC Code to Model Fast Electron Beam Transport Through Dense Matter

Hybrid Simulation Of Interaction Between Electron-Beam-Generated Plasmas And Air Flow

Hybrid fluid–particle modeling of shock-driven hydrodynamic instabilities in a plasma

Development of A 2.5-Dimensional Particle-In-Cell Code for Efficient High-Power Klystron Design

Mitigation of Numerical Cerenkov Radiation and Instability Using a Hybrid Finite Difference-Fft Maxwell Solver and a Local Charge Conserving Current Deposit

A two-dimensional hybrid model of the Hall thruster discharge

An efficient numerical method for charged particle transport based on hybrid collision model and machine learning

Transport of intense ion beams in plasmas: collimation and energy-loss reduction

A new hybrid code (CHIEF) implementing the inertial electron fluid equation without approximation

Particle simulation of collision dynamics for ion beam injection into a rarefied gas

A hybrid model for low pressure inductively coupled plasmas combining a fluid model for electrons with a plasma-potential-dependent energy distribution and a fluid-Monte Carlo model for ions

A Fluid-Kinetic Hybrid Electron Model for Electromagnetic Simulations

Two-dimensional hybrid-direct kinetic simulation of a Hall thruster discharge plasma

One-dimensional, hybrid hydrodynamics-Boltzmann model for electron beam generated plasmas produced in low pressure argon

Hybrid particle-spectral method for kinetic plasma simulations

Particle-in-cell Simulation of Transport and Energy Deposition of Intense Proton Beams in Solid-State Materials

Intense-laser Generated Relativistic Electron Transport in Coaxial Two-Layer Targets

Analytical Model for Estimating the Equilibrium Plasma Quantities in an Electron Beam–plasma System

Full wave modeling of radio-frequency beams in tokamaks in the electron cyclotron frequency range