Abstract:A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .

A Gain Control Baseline Circuit of the Analog Front-End Circuit for the 1000Base-T Ethernet Transceiver

Pre-equalizer for 1000baset Ethernet Transceiver

A 1.8 V Analog Front-End for Gigabit Ethernet Receiver

A Wideband Db-Linear VGA with Temperature Compensation and Active Load

An Ultra-low Noise Variable Gain Amplifier with Accurate dB-Linear Characteristic

An Accurate Db-Linear CMOS VGA Based on Double Duplicate Biasing Technique

A 0.96-mW dB-Linear Variable Gain Amplifier With 0.4-dB Linearity Error Over a 62.4-dB Gain Tuning Range

A Wideband BiCMOS Variable Gain Amplifier with Novel Continuous Db-Linear Gain Control and Temperature Compensation

A novel accurate dB-linear control circuit topology for variable gain amplifiers in BiCMOS technology

A Linear-in-Decibel Automatic Gain Control Amplifier with Dual Mode Continuous Gain Tuning

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

A Wideband Digital Variable Gain Amplifier with DC Offset Cancellation in SiGe 0.18µm BiCMOS Technology

Equalizer for 10Base-T/100base-tx Ethernet Transceiver Based on DSP Structure

A 1.8 V Low-jitter Clock Generator for 1000 Base-T Ethernet Transceiver

A 0.8–3 GHz RF-VGA with 35 Db Dynamic Range in 0.13 Μm CMOS

A CMOS High Dynamic Range Variable Gain Amplifier

A High Efficient CTLE for 12.5 Gbps Receiver of JESD204B Standard

A 60-Db Linear VGA with Novel Exponential Gain Approximation

A 20–43-GHz Low Phase Variation VGA With Feedforward Signal Suppression and Impedance-Invariant Techniques in 65-nm CMOS

A 10Gb/s analog equalizer in 0.18um CMOS

3 V low-jitter frequency synthesizer for a fast ethernet transceiver