Abstract:A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .

A 0.8–3 GHz RF-VGA with 35 Db Dynamic Range in 0.13 Μm CMOS

An Ultra-low Noise Variable Gain Amplifier with Accurate dB-Linear Characteristic

A Wideband Db-Linear VGA with Temperature Compensation and Active Load

Linear-in-decibel variable gain amplifier design in 0.18µm SIGE BICMOS technology

A 0–35dB wideband variable gain amplifier in 0.13μm CMOS

An Accurate Db-Linear CMOS VGA Based on Double Duplicate Biasing Technique

A 0.96-mW dB-Linear Variable Gain Amplifier With 0.4-dB Linearity Error Over a 62.4-dB Gain Tuning Range

A Wideband BiCMOS Variable Gain Amplifier with Novel Continuous Db-Linear Gain Control and Temperature Compensation

A 0.8-3GHz 40dB dynamic range CMOS variable-gain amplifier

A Wideband Digital Variable Gain Amplifier with DC Offset Cancellation in SiGe 0.18µm BiCMOS Technology

A Linear-in-Decibel Automatic Gain Control Amplifier with Dual Mode Continuous Gain Tuning

A 1ghz, 56.7db Linear-in-dB CMOS Wideband Variable Gain Amplifier

A 1.5mA 470MHz CMOS variable gain amplifier for wideband communication

A PVT-Robust 2.4-Ghz-bw 59.7-Db-range 0.39-Db-error Db-Linear VGA with Self-Compensated Exponential Generator and Self-Adaptive Bias

A CMOS Wideband Variable Gain Amplifier

A 60-Db Linear VGA with Novel Exponential Gain Approximation

A CMOS High Dynamic Range Variable Gain Amplifier

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 20–43-GHz Low Phase Variation VGA With Feedforward Signal Suppression and Impedance-Invariant Techniques in 65-nm CMOS

A novel accurate dB-linear control circuit topology for variable gain amplifiers in BiCMOS technology