Abstract:In this paper, we study the deformation behavior of nickel-based superalloys by in-situ EBSD and uniaxial tensile tests. This study mainly focuses on the microstructure evolution in the same area of the sample during deformation, including the evolution of various types of grain boundaries, geometrically necessary dislocations, grain orientations and texture, and their effect on the mechanical properties. The results show that the rotation of grains is closely related to their initial orientation during deformation. The lattice of grain is rotated to a certain extent to accommodate the more favorable orientation under low strain, leading to higher Schmid factors for the sample. Under large stresses, the grains occur deformation, multiple slip systems start simultaneously or alternately and the Schmid factors value gradually tends to stabilize at a lower level. Meanwhile, the texture orientation density of the initial Rotating cubic {001} texture, α-fiber (RD// ) texture, and γ-fiber (ND // ) gradually decrease or even disappears, while the texture orientation density of Copper {112} and Goss {011} increases during uniaxial tensile deformation for Cr20Ni80 alloy. Grain rotation may be a result of large strain due to stress triaxiality and resulting plane stress condition owing to specimen dimension, which is beneficial to improve the plastic deformability of the alloy. Interestingly, with the increase of strain, the average misorientation angle first decreases and then increases, which is associated with the dislocation density. In addition, serious torsion occurs in the grains during this process, forming a large number of substructures. These substructures result in grain refinement and the Hall-Petch effect. In fact, during the deformation process, multiple strengthening mechanisms act in coordination, leading to an increase in the strength of the alloy.

Microstructure and Texture after Deformation-induced Grain Growth in Polycrystalline Ni48Mn30Ga22 Alloys

Compressive Deformation of Polycrystalline Ni-Mn-Ga Alloys Near Chemical Ordering Transition Temperature

Introducing Equiaxed Grains and Texture into Ni-Mn-Ga Alloys by Hot Extrusion for Superplasticity

Grain size dependent microstructure and texture evolution during dynamic deformation of nanocrystalline face-centered cubic materials

γ′-size effect on the deformation microstructure and texture in a Ni-based superalloy using in-situ neutron diffraction

Microstructural and texture evolution investigation of laser melting deposited TA15 alloy at 500?C using in-situ EBSD tensile test

Microstructure and Texture Evolution of Cu-Ni-P Alloy after Cold Rolling and Annealing

Effect of different deformation and annealing procedures on non-magnetic textured Cu60Ni40 alloy substrates

Microstructural evolution in an Ni-Mn-Ga alloy during compression

Deformation and Fracture Mechanisms of an Annealing-Tailored "bimodal" Grain-Structured Mg Alloy

Microstructure and Microtexture Evolution of Dynamic Recrystallization of a Ni-based Superalloy under High-Throughput Gradient Thermal Compression

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

Manipulation of microstructure evolution and deformation behavior in Ni–Mn–Ga shape memory alloys with varied Ni/Ga under uniaxial cyclic compression

In-situ EBSD study of deformation behavior of nickel-based superalloys during uniaxial tensile tests

Dynamic Recrystallization Behavior and Texture Evolution of NiAl Intermetallic During Hot Deformation

Effect of cross cold rolling and annealing on microstructure and texture in pure nickel

Preferential grain growth and textural evolution of AZ31B Mg alloy during annealing after isothermal compression at 400 °C

Systematical Analysis on the Grain Orientation Evolution of Pure Nickel under Plastic Deformation by Using In-Situ EBSD

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Texture Evolution and Plastic Deformation Mechanism of Cold-Drawn Co-Cr-Ni-Mo Alloy

Microstructure and texture evolution of pure molybdenum during hot deformation