Abstract:Poly(lactic acid) (PLA) is a bio-based and compostable thermoplastic polyester that has rapidly evolved into a competitive commodity material over the last decade. One key bottleneck in expanding the field of application of PLA is the control of its structure and properties. Therefore, in situ investigations under cooling are necessary for understanding the relationship between them. The most intriguing feature of a supercooled liquid is its dramatic rise in viscosity as it is cooled toward the glass transition temperature (T-g) though accompanied by very little change in the structural features observable by typical X-ray experiments. The deformation behaviors and structure evolution of glassy PLA during uniaxially stretching below Tg were investigated in situ by synchrotron small-angle X-ray scattering (SAXS) and wide-angle X-ray scattering (WAXS) techniques. The stretched samples were measured by differential scanning calorimetry (DSC). The obtained results showed that the deformation and yield stress of glassy PLA are strongly dependent on the stretching temperatures together with the transition from mesophase to mesocrystal and the formation of cavities. With the increase in drawing temperature, the onset of the mesocrystal formation is delayed to a higher strain value, whereas corresponding to the same critical orientation degree of amorphous chains (f(am) approximate to 0.45). The DSC results indicated that the post-T-g endothermic peak corresponding to the melting of mesocrystal appears and shifts to a higher temperature with increasing stretching temperature, followed by the down-shifts (to a lower temperature) of the exothermic peak of cold crystallization of PLA. The appearance of a small exothermic peak just before the melting peak related to the transition of the alpha' to alpha crystal implies the formation of an alpha' crystal during cold crystallization in the drawn PLA samples. The structure evolution of glassy PLA stretched below T-g was discussed in details.

Structural Transition Of Poly(L-Lactic Acid) Film Induced By Compression At Air/Water Interface

Polymorphic Transition in Disordered Poly(l-lactide) Crystals Induced by Annealing at Elevated Temperatures

Effects of Subphase Ph and Temperature on the Aggregation Behavior of Poly(lauryl Acrylate)-Block-poly(n-isopropylacrylamide) at the Air/Water Interface

Structure and Surface Nanomechanics of Poly(l-Lactide) from Thermally Induced Phase Separation Process

Ductile and biodegradable poly (lactic acid) matrix film with layered structure

Effect of biaxial stretching on the microstructure evolution, optical, mechanical and oxygen barrier properties of biodegradable poly(lactic acid) (PLA)/poly(butylene adipate- co -terephthalate) (PBAT) films

Structure evolution of amorphous poly(d-lactic acid) on highly oriented poly(l-lactic acid) film during annealing

Polymers at the Water/air Interface, Surface Pressure Isotherms, and Molecularly Detailed Modeling.

Conformational Changes of Poly(n-Isopropylacrylamide) Chains at Air/water Interface: Effects of Temperature, Compression Rate, and Packing Density.

Deep Insight into the Effect of Microstructure Evolution on Film-Forming Properties of Polylactide During Uniaxial Hot-Stretching Process

Crystal Structure and Unique Lamellar Thickening for Poly(l-Lactide) Induced by High Pressure

Construction of fully biodegradable poly(L-lactic acid)/poly(D-lactic acid)-poly(lactide-co-caprolactone) block polymer films: Viscoelasticity, processability and flexibility

Crystalline Structures of Poly(l-Lactide) Formed under Pressure and Structure Transitions with Heating

Foaming of Poly(lactic Acid) Based on Its Nonisothermal Crystallization Behavior under Compressed Carbon Dioxide

Polylactide Films with Superhydrophobicity and Superior Mechanical Properties Constructed by Combining Annealing Stretching and Nonsolvent-Induced Phase Separation

A Real‐time WAXS and SAXS Study of the Structural Evolution of LLDPE Bubble

Structure Evolution of Oriented Poly( l -lactic acid) Ultrathin Films during Deformation

Deformation and structure evolution of glassy poly(lactic acid) below the glass transition temperature

Comparative Study on Water Vapour Resistance of Poly(lactic acid) Films Prepared by Blending, Filling and Surface Deposit

Long chain branching polylactide: Structures and properties

Oriented Overgrowths Of Poly(L-Lactide) On Oriented Isotactic Polypropylene: A Sequence Of Soft And Hard Epitaxies