Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Thermodynamic Analysis Of A Sco2 Part-Flow Cycle Combined With An Organic Rankine Cycle With Liquefied Natural Gas As Heat Sink

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Thermodynamic Analysis of an Innovative Transcritical CO2 Parallel Rankine Cycle Driven by Engine Waste Heat and Liquefied Natural Gas Cold

Off-design Behavior Investigation of the Combined Supercritical CO2 and Organic Rankine Cycle

Thermo-economic analysis and optimization of a cascade transcritical carbon dioxide cycle driven by the waste heat of gas turbine and cold energy of liquefied natural gas

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

Thermodynamic analysis of an SOFC-GT-ORC integrated power system with liquefied natural gas as heat sink

Preliminary Conceptual Design and Thermo-Economic Analysis of a Combined Cooling, Heating and Power System Based on Supercritical Carbon Dioxide Cycle

Thermo-Economic Analysis Of A Recompression Supercritical Co2 Cycle Combined With A Transcritical Co2 Cycle

Thermodynamic analysis of a transcritical CO2 power cycle driven by solar energy with liquified natural gas as its heat sink

Exergoeconomic Analysis of Utilizing the Transcritical CO2 Cycle and the ORC for a Recompression Supercritical CO2 Cycle Waste Heat Recovery: A Comparative Study

Thermodynamic and exergoeconomic analysis of combined supercritical CO2 cycle and organic Rankine cycle using CO2-based binary mixtures for gas turbine waste heat recovery

A partial heating supercritical CO2 nested transcritical CO2 cascade power cycle for marine engine waste heat recovery: Thermodynamic, economic, and footprint analysis

A 3E analysis of a multi‐power generation system employing CO2, LNG, and Organic Rankine cycles

Thermodynamic analysis and parametric optimization of a novel S–CO2 power cycle for the waste heat recovery of internal combustion engines

Performance Assessment and Multi-Objective Optimization of a Novel Transcritical CO2 2 Rankine Cycle for Engine Waste Heat Recovery

Design and Performance Analyses for a Novel Organic Rankine Cycle with Supercritical-Subcritical Heat Absorption Process Coupling

Thermodynamic Optimization on Supercritical Carbon Dioxide Brayton Cycles to Achieve Combined Heat and Power Generation

Design and Analysis of the Combined Cycle With the Micro Gas Turbine and Organic Rankine Cycle Settings

Performance Assessment and Multi-Objective Optimization of a Novel Transcritical CO2 Rankine Cycle for Engine Waste Heat Recovery

Off-design Performance Analysis of a Transcritical CO2 Rankine Cycle with LNG As Cold Source