Abstract:Purpose: Computational fluid dynamics (CFD) and 4D-flow magnetic resonance imaging (MRI) are synergically used for the simulation and the analysis of the flow in a patient-specific geometry of a healthy thoracic aorta. Methods: CFD simulations are carried out through the open-source code SimVascular. The MRI data are used, first, to provide patient-specific boundary conditions. In particular, the experimentally acquired flow rate waveform is imposed at the inlet, while at the outlets the RCR parameters of the Windkessel model are tuned in order to match the experimentally measured fractions of flow rate exiting each domain outlet during an entire cardiac cycle. Then, the MRI data are used to validate the results of the hemodynamic simulations. As expected, with a rigid-wall model the computed flow rate waveforms at the outlets do not show the time lag respect to the inlet waveform conversely found in MRI data. We therefore evaluate the effect of wall compliance by using a linear elastic model with homogeneous and isotropic properties and changing the value of the Young's modulus. A stochastic analysis based on the polynomial chaos approach is adopted, which allows continuous response surfaces to be obtained in the parameter space starting from a few deterministic simulations. Results: The flow rate waveform can be accurately reproduced by the compliant simulations in the ascending aorta; on the other hand, in the aortic arch and in the descending aorta, the experimental time delay can be matched with low values of the Young's modulus, close to the average value estimated from experiments. However, by decreasing the Young's modulus the underestimation of the peak flow rate becomes more significant. As for the velocity maps, we found a generally good qualitative agreement of simulations with MRI data. The main difference is that the simulations overestimate the extent of reverse flow regions or predict reverse flow when it is absent in the experimental data. Finally, a significant sensitivity to wall compliance of instantaneous shear stresses during large part of the cardiac cycle period is observed; the variability of the time-averaged wall shear stresses remains however very low. Conclusions: In summary, a successful integration of hemodynamic simulations and of MRI data for a patient-specific simulation has been shown. The wall compliance seems to have a significant impact on the numerical predictions; a larger wall elasticity generally improves the agreement with experimental data.

EXPERIMENTAL VALIDATION OF ULTRASONIC-MEASUREMENT-INTEGRATED SIMULATION FOR BLOOD FLOW IN AORTA

1307 Numerical Experiment and Experimental Application of Ultrasonic-Measurement Integrated-Simulation with PVA Straight Pipe Model(1)

Experimental Study on Hemodynamics of an End-to-side Anastomosis

NUMERICAL EXPERIMENT FOR ULTRASONIC-MEASUREMENT-INTEGRATED SIMULATION OF DEVELOPED LAMINAR PIPE FLOW USING AXISYMMETRIC MODEL

Development and Feasibility Study of a Two-Dimensional Ultrasonic-Measurement-integrated Blood Flow Analysis System for Hemodynamics in Carotid Arteries.

Experimental Validation of Color Doppler Velocity Measurement for Ultrasonic-Measurement-Integrated Simulation of Blood Flow

NUMERICAL REALIZATION OF BLOOD FLOW IN ANEURYSMAL AORTA BY INTEGRATING MEASUREMENT AND SIMULATION

Numerical simulation of two-phase non-Newtonian blood flow with fluid-structure interaction in aortic dissection

Investigation of pulsatile flowfield in healthy thoracic aorta models

Investigations into the Potential of Using Open Source CFD to Analyze the Differences in Hemodynamic Parameters for Aortic Dissections (Healthy versus Stanford Type A and B)

Validation of Numerical Simulations of Thoracic Aorta Hemodynamics: Comparison with In Vivo Measurements and Stochastic Sensitivity Analysis

A novel formulation for the study of the ascending aortic fluid dynamics with in vivo data

A Modified Method of Computed Fluid Dynamics Simulation in Abdominal Aorta and Visceral Arteries

Abstract 589: A Fluid Structure Interaction Workflow For Studying Aortic Dissections

Three-dimensional Simulation of Blood Flow in Human Thoracic Aorta

Helical Flow As a New Determinant of Coronary Plaque Vulnerability: a Glimpse into the Future

Numerical study of blood flow in an anatomically realistic aorto-iliac bifurcation generated from MRI data

Validation of the Reduced Unified Continuum Formulation Against In Vitro 4D-Flow MRI

Quantitative Hemodynamics in Aortic Dissection: Comparing in Vitro MRI with FSI Simulation in a Compliant Model

A proposal of risk indicators for pathological development from hemodynamic simulation: application to aortic dissection

Numerical simulation of hemodynamics in aortic dissection