Influence of Synthesis Method on Catalytic Properties and Hydrothermal Stability of Cu/SSZ-13 for NH3-SCR Reaction
Han Jiang,Bin Guan,Xuesong Peng,Reggie Zhan,He Lin,Zhen Huang
DOI: https://doi.org/10.1016/j.cej.2019.122358
IF: 15.1
2019-01-01
Chemical Engineering Journal
Abstract:This study focuses on investigating the influence of ion-exchange method (ION-F and ION-A) and one-pot method (ONE-F and ONE-A) on catalytic properties and hydrothermal stability of Cu/SSZ-13. It was found that ONE-F catalyst showed better SCR activity, especially at low temperature range below 400 degrees C. After hydrothermal aging, ION-A exhibited higher low temperature efficiency than ONE-A. The effect of synthesis method on the physicochemical structure, acidity intensity, and Cu species migration or transformation of the fresh and aged Cu/SSZ-13 catalysts were comprehensively characterized by NH3-TPO, H-2-TPR, NH3-TPD, ICP, XRF, BET, XRD, SEM, and TEM. ONE-F has more isolated Cu2(+) sites, higher ratio of active sites Cu2+-2ZACu(OH)](+)-Z, more Lewis acid sites, and smaller particle size than ION-F. However, hydrothermal aging had severe effect on Cu/SSZ-13 prepared by one-pot method, leading to particle aggregation and decrease of active copper sites. According to NH3-SCR kinetic studies, smaller particle size and more uniformly distributed active sites over ONE-F resulted in less effect of pore diffusion limitation. Furthermore, in situ DRIFTS results indicated that more monodentate nitrates adsorbed sites and Lewis acid sites existed in ONE-F. On the other hand, monodentate nitrates were identified to be the most active nitrate species, and Lewis acid sites were ascertained to be more active than Bronsted acid sites. Therefore, ONE-F showed more excellent SCR performance than ION-F. However, hydrothermal aging resulted in loss of majority of nitrate adsorbed sites and acid sites over catalyst prepared by one-pot method, leading to lower SCR performance. In conclusion, Cu/SSZ-13 prepared by ion-exchange method has higher hydrothermal stability, however, fresh Cu/SSZ-13 prepared by one-pot method has excellent catalytic properties.