Abstract:Development of large-area, low-cost, low-voltage, low-power consumption, flexible high-performance printed carbon nanotube thin-film transistors (TFTs) is helpful to promote their future applications in sensors and biosensors, wearable electronics, and the Internet of things. In this work, low-voltage, flexible printed carbon nanotube TFTs with a large-area and low-cost fabrication process were successfully constructed using ultrathin (∼3.6 nm) AlOx thin films formed by plasma oxidation of aluminum as dielectrics and screen-printed silver electrodes as contact electrodes. The as-prepared bottom-gate/bottom-contact carbon nanotube TFTs exhibit a low leakage current (∼10–10 A), a high charge carrier mobility (up to 9.9 cm2 V–1 s–1), high on/off ratios (higher than 105), and small subthreshold swings (80–120 mV/dec) at low operation voltages (from −1.5 to 1 V). At the same time, printed carbon nanotube TFTs showed a high response (ΔR/R = 99.6%) to NO2 gas even at 16 ppm with a faster response and recovery speed (∼8 s, exposure to 0.5 ppm NO2), a lower detection limit (0.069 ppm NO2), and a low power consumption (0.86 μW, exposure to 16 ppm NO2) at a gate voltage of 0.2 V at room temperature. Moreover, the printed carbon nanotube devices exhibited excellent mechanical flexibility and bias stress stability after 12,000 bending cycles at a radius of 5 mm and a bias stress test for 7200 s at a gate voltage of ±1 V, which originated from the ultrathin and compact AlOx dielectric and the super adhesion force between screen-printed silver electrodes and polyethylene terephthalate substrates.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c13824?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c13824</a>.Characteristics of SWCNT materials used for sensors; absorption spectrum and SEM image of sorted SWCNTs; schematic illustration of the definition of the SWCNT peak ratio [φi = ACNT/(ACNT + AB)]; Raman spectra of sorted SWCNT thin films; leakage currents of printed SWCNT TFTs with different metal electrodes, inkjet-printed silver electrodes, evaporated aluminum electrodes, and screen-printed silver electrodes using five different commercial silver pastes; power consumption of the device when exposed to 0.5–16 ppm NO2; transfer curves of four different SWCNT TFT devices before and after exposure to 40 ppm NO2 for 30 min and after the gas desorption process; transfer curves of a SWCNT TFT device after exposure to 4–16 ppm NO2; changes in threshold voltage and off-current after exposure to 4–16 ppm NO2; transfer curve of SWCNT TFTs with different dielectric layers and electrode materials before and after exposure to 16 ppm NO2 gas; alumina as the dielectric layer and palladium as source and drain electrodes; hafnium dioxide as the dielectric layer and gold as the source and drain electrodes; alumina as the dielectric layer and gold as the source and drain electrodes; transfer curves of flexible printed SWCNT TFTs before and after bending for 12,000 times; changes in the transfer curves of four different SWCNT TFTs after 12,000 bending cycles; thickness and profile of the screen-printed silver electrode measured using a step profiler (Veeco, Dektak 150); adhesion test of screen-printed silver electrodes on PET substrates; schematic diagram of NO2 gas sensing; response characteristics of a transistor-type sensor to 8 ppm NO2 at different gate voltages, with gate voltages of −0.2, 0.2, 0.4, 0.6, 0.8, 1, 1.5, and 2 V; relationship between the response time and the NO2 concentrations for two transistor-type and resistance-type sensors; repeatability of the transistor-type sensor; selectivity of the transistor-type sensor; fitted response of the SWCNT-TFT sensor to NO2; polynomial fitting plot of resistance versus time before NO2 exposure; response plots of the device under different NO2 concentrations; polynomial fitting data; and calculation of root-mean-square (RMS) noise and limit of detection<a class="ref ref57 ref68" href="">(57,68)</a> (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c13824/suppl_file/am0c13824_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Thin Film Transistors Based On Single-Walled Carbon Nanotubes-Polyethylenimine Bilayer Film For No2 Gas Detection

Thin Film Transistors Gas Sensors Based on Poly(3-Hexylthiophene)/zinc Oxide-Nanorods Composite Film for Nitrogen Dioxide Detection

Flexible organic thin-film transistors based on poly(3-hexylthiophene) films for nitrogen dioxide detection

Thin film transistors gas sensors based on reduced graphene oxide poly(3-hexylthiophene) bilayer film for nitrogen dioxide detection

Ultrasensitive flexible NO2 gas sensors via multilayer porous polymer film

Large-Area Flexible Printed Thin-Film Transistors with Semiconducting Single-Walled Carbon Nanotubes for NO 2 Sensors

Thickness Modulation on Semiconductor Towards High Performance Gas Sensors Based on Organic Thin Film Transistors

Sub-ppm and High Response Organic Thin-Film Transistor NO2 Sensor Based on Nanofibrillar Structured TIPS-pentacene

Interfacial Modifying Layer-Driven High-Performance Organic Thin-Film Transistors and Their Nitrogen Dioxide Gas Sensors

High Performance Nitrogen Dioxide Sensor Based on Organic Thin-Film Transistor Utilizing P3HT/OH-MWCNTs Blend Film

Poly(3-hexylthiophene) based Organic field-effect transistor as NO 2 gas sensor

Phase separation of P3HT/PMMA blend film formed semiconducting and dielectric layers in organic thin-film transistors for high sensitivity NO2 detection.

Large-Area Flexible Printed Thin-Film Transistors with Semiconducting Single-Walled Carbon Nanotubes for NO2 Sensors.

P1FW.3 - Flexible Organic Thin-Film Transistors NO2 Sensors Based on Poly(3-Hexylthiophene)/graphene Composite Films

Single-Walled Carbon Nanotube-Based Gas Sensors for No2 Detection

Recent Progress of Organic Thin Film Transistors Gas Sensors

Organic Thin-Film Transistors Gas Sensor Based on Highly Compact and Ordered Phthalocyanine Semiconducting Nanofilms

A Flexible NO2 Gas Sensor Based on Single-Wall Carbon Nanotube Films Doped with a High Level of Nitrogen

P3HT/surfactant Blend Films in Organic Thin-Film Transistors for High-Performance NO2 Detection

The Investigation of a New NO2 OTFT Sensor Based on Heterojunction F16CuPc/CuPc Thin Films

Phase Separation of P3HT/PMMA Blend Film for Forming Semiconducting and Dielectric Layers in Organic Thin-Film Transistors for High-Sensitivity NO2 Detection