Abstract:<p>In this work, adapted from the concept of cavity, a new model of receiver tube presented and used in one direct-absorption solar collector (DASC) equipped with two linear parabolic reflectors (LPR). Using both the insulated wall and the cavity-like receiver tube minimize the energy loss in this new-presented receiver tube. Its other advantage is the increase of sun-rays path length created by the sequential reflections of rays in the receiver tube which leads to the attenuation of nanoparticle agglomeration. Therefore, the effect of mentioned two advantages of receiver tube as well as the effect of nanoparticles is analyzed separately. The new presented receiver tube with the absorbent walls is utilized in surface-base solar collector (SBSC) to survey the effect of using the nanoparticle. Also, to investigate the effect of using new-presented absorber tube in SBSC, the obtained results are compared with the conventional type of SBSC. For these purposes, after the sun-rays tracing conducted by a mathematical method, the numerical simulation is carried out by COMSOL software to investigate some effective parameters. Accordingly, using nanoparticle in the new-presented DASC enhances the efficiency by 5% than SBSC. Also, using the new presented cavity-like receiver tube in SBSC augments the efficiency up to 2% rather than conventional LS-2 collector. Finally, as the prominent finding of the current work, the highly-efficient DASC (i.e., 81%) can be achieved using the lower percentage of nanoparticle (i.e., <span class="math"><math>α=0.07</math></span>).</p>

Improvements in Vacuum Collector Tubes with Graded Ai-N/Ai Absorbing Surfaces

Single cathode sputtered selective solar absorbing surfaces

Graded Al-N/Al Absorbing Surfaces for All-Glass Evacuated Tubular Collectors - R, D and Production: Bridging the Gap

Improvements Of Measuring The Hemispherical Emittance Of Selective Coating For All-Glass Evacuated Collector Tubes

Sputtered Aluminium-Nitrogen Solar Absorbing Selective Surfaces For All-Glass Evacuated Collectors

Preparation of Anti-Reflection Coatings on Quartz Tube Surfaces Based on Atomic Layer Deposition

Processing Technology of Spectrally Selective Absorption Coatings Used for Flat Collector

Sputtered solar selective absorbing surfaces based on aluminum and stainless steel composites

Developments of CPC solar evacuated glass tube collector with a novel selective coating

Graded solar selective absorbers deposited by non-equilibrium RF magnetron sputtering

Preparation of Aluminide Coatings on the Inner Surface of Tubes by Heat Treatment of Al Coatings Electrodeposited from an Ionic Liquid

STUDY OF MEDIUM-FREQUENCY SPUTTERING OF GRADED Al-AlN SOLAR SELECTIVE ABSORBERS

Sputtered Aluminium Composite Selective Absorbing Surfaces

Medium-temperature Solar Collectors with All-glass Solar Evacuated Tubes

Air-Type Vacuum-Tube Solar Collector Design and Heat Collection Performance Test

Study on the residual gas in all-glass evacuated collector tubes

Microstructure and Thermal Stability of Cu/TixSiyN/AlSiN Solar Selective Absorbing Coating

A Novel Design For High-Temperature Solar Selective Coating

Low emissivity thin film coating to enhance the thermal conversion efficiency of Selective Solar Absorber in High Vacuum Flat Plate Collectors

STUDY ON THE RESIDUAL GAS IN GLASS EVACUATED COLLECTOR TUBES WITH VARIOUS GETTERS

Thermal performance enhancement of direct absorption solar collector using nanoparticle in sunray trap