Abstract:Because of their beautiful appearance, strong crossing ability, and reasonable stress performance, the application of tied steel box arch bridges is becoming more and more extensive. Bridge construction monitoring can control and adjust the deviation state to ensure the stress and linear state of the bridge after completion. This study carried out a symmetrical construction monitoring analysis and completed state evaluation of the newly built Dafeng River Bridge in Guangxi Province based on the finite element method. MIDAS Civil finite element software is used for simulation analysis to calculate the deformation and stress of the tied steel box arch bridge at the construction and completion stages. The tensile and compressive stress of the main arch and transverse brace, as well as the cumulative displacements of the main arch and lattice beam, are symmetrically distributed. The maximum tensile and compressive stresses are 15.1 MPa and 74.6 MPa, respectively, less than the specification's allowable value. Meanwhile, for the completed bridge under the loading combinations of serviceability limit state and bearing capacity ultimate limit state, the stress of the main arch, transverse brace, and lattice beam meets the specification requirements. The maximum cable forces of the suspender and tie rod under the bearing capacity ultimate limit state are 2189.4 kN and 2991.2 kN, and their corresponding minimum safety factors are 3.2 and 2.7. In addition, the deviations between the on-site monitoring and the finite element theoretical values are within the specification allowable range for the cable force of the suspender and tie rod and the bridge deck alignment. It indicates that the bridge construction monitoring effect is reasonable and ideal, and the symmetrically finite element simulation analysis can provide a theoretical basis for construction monitoring.

Risk Assessment of a Long Span Unsymmetrical Extroversion Arch Bridge

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Structural design and analysis of a large span partially single-sided cable-stayed pedestrian bridge

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Calculation of stayed-buckle cable forces for concrete-filled steel tubular arch bridge with long span in process of lifting

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Analysis of the Existing Reinforced Concrete Rigid Frame Arch Bridge Strengthened with Arch and Cable System

Stress Performance Analysis of Special-shaped Arch Bridge with Longitudinal Linkage

Reinforced Concrete Multi-Rib Arch Bridge Strengthened by Changing Structural System

Multi-rib Arch Bridge Strengthened by Stayed-Cable and Field Test

Safety Assessment of Large Span Cable-stayed Bridge

Ultimate behavior of long-span steel arch bridges

Novel long-span cable-stayed deck arch bridge: Concept and structural characteristics

A Long-span Network Arch Bridge for Road and Rail Traffic

Behaviour Analysis of Prestressed Concrete Deck-Tied Arch Bridge

Symmetrically Construction Monitoring Analysis and Completed State Evaluation of a Tied Steel Box Arch Bridge Based on Finite Element Method

Key Construction Technology and Monitoring of Long-Span Steel Box Tied Arch Bridge

Risk assessment for a long-span cable-stayed bridge subjected to multiple support excitations

Life-cycle based structural performance of long-span CFST hybrid arch bridge: A study on arch of Pingnan Third Bridge

Wind-induced Load Capacity Analysis and Parametric Study of a Long-Span Steel Arch Bridge under Construction

Structural Analysis and Application of Long Span Suspension Bridge