Abstract:The study of material properties relies on accurate and reliable testing instruments. Sensitively capturing changes in material performance is key to understanding the mechanisms of material properties. The Seebeck coefficient and resistivity testing instrument are essential for research on many functional materials. However, the current instrument is limited in its ability to capture sensitive changes due to testing principles. Here, we prepared three different types of non-equilibrium Zn 4 Sb 3 . We found that the existing static testing instrument has problems with testing interruption or inaccuracy when the sample undergoes chemical reactions, rapid atomic diffusion, or phase transitions. The cause of interruption is that the temperature control setting cannot meet the accuracy requirements of the testing instrument. The instrument's large temperature difference setting will cause the determination of the phase transition temperature to become inaccurate. To address the limitations, we have developed a dynamic testing instrument and tested the Seebeck coefficient and resistivity of Zn 4 Sb 3 and Ni in the range of 300 K–800 K. By ensuring the accuracy of each module of the instrument, optimizing the alternating temperature rise time, and improving the data acquisition calculation method, we have achieved accurate capture of sensitive performance changes in the non-equilibrium sample. Comparatively, dynamic testing reduces the measurement time by approximately 300 % compared to static testing. The standard deviation of measured Seebeck coefficient and resistivity is less than ±4 %. This study demonstrates that dynamic testing of the Seebeck coefficient and resistivity is an effective strategy for measuring non-equilibrium functional materials.

An Alternating-Current Voltage Modulated Thermal Probe Technique for Local Seebeck Coefficient Characterization

Ac heating-dc detecting method for Seebeck coefficient measurement of the thermoelectric micro/nano devices

A Self-Heating 2ω Method for Seebeck Coefficient Measurement of Thermoelectric Materials.

Precise measurement of absolute Seebeck coefficient from Thomson effect using ac-dc technique

Novel Ac Heating–dc Detection Method for Active Thermoelectric Scanning Thermal Microscopy

A Setup for Measuring the Seebeck Coefficient and the Electrical Resistivity of Bulk Thermoelectric Materials

Direct Mapping of Local Seebeck Coefficient in 2D Material Nanostructures via Scanning Thermal Gate Microscopy

Fast Seebeck Coefficient Measurement Based on Dynamic Method.

Electron-Phonon Interaction Enables Strong Thermoelectric Seebeck Effect Variation in Hybrid Nanoscale Systems

Method and system for measuring quasi one-dimensional nano-material Seebeck coefficient

Simultaneous thermal conductivity and specific heat measurements of thin samples by transient Joule self-heating

A METHOD FOR THERMOELECTRIC MEASUREMENTS ON MESOSCOPIC SAMPLES

Measurement of non-equilibrium characteristics of thermoelectric materials

A hot probe setup for the measurement of Seebeck coefficient of thin wires and thin films using integral method

Ac Thermoelectric Response in the Nanostructure and Corresponding Nonlinear Kinetic Coefficients

An in-situ thermoelectric measurement apparatus inside a thermal-evaporator

A three-probe method for accurate nanoscale thermal transport measurements

Three-wire Method to Characterize the Thermoelectric Properties of One-Dimensional Materials

Electron-Beam Activated Thermal Sputtering of Thermoelectric Materials

Microstructures for Characterization of Seebeck Coefficient of Doped Polysilicon Films

A contactless scanning near-field optical dilatometer imaging the thermal expansivity of inhomogeneous 2D materials and thin films at the nanoscale