Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

Consideration of flyback converter using GaN devices

A Digital PWM Controller of MHz Active Clamp Flyback with GaN Devices for AC-DC Adapter.

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

An Optimization Method for Planar Transformer Winding Losses in GaN Based Multi-output Flyback Converter

Design and Analysis of GaN-Based Parallel Flyback Circuit

Comparisons on Different Innovative Cascode GaN HEMT E-Mode Power Modules and Their Efficiencies on the Flyback Converter

Design Considerations of an Isolated GaN Bidirectional Dc-Dc Converter

Design and Implementation of GaN-Based Two Switch Flyback With Synchronous Rectification for New Space Applications

FoM Based Optimal Frequency and Voltage Level Design for High Efficiency High Density Multilevel PFC with GaN Device

Analysis of MHz 380V-12V DCX with Low FoM Device

A Unified Switch Loss Model and Design Consideration for Multilevel Boost PFC with GaN Devices

Loss Analysis of GaN Devices in an Isolated Bidirectional DC-DC Converter

Very-High-Frequency Resonant Flyback Converter with Integrated Magnetics

Gallium-Nitride Semiconductor Technology and Its Practical Design Challenges in Power Electronics Applications: An Overview

A Comparative Study on the Switching Performance of GaN and Si Power Devices for Bipolar Complementary Modulated Converter Legs

Virtual Prototype and GaN HEMT Based High Frequency LLC Converter Design

Design of a GaN Totem-Pole PFC Converter Using DC-Link Voltage Control Strategy for Data Center Applications

Analysis and Optimization of a Regenerative Snubber for a GaN-Based USB-PD Flyback Converters

20.3 A GaN Gate Driver with On-chip Adaptive On-time Controller and Negative Current Slope Detector