Effect of Physico-Chemical Parameters on Inorganic Arsenic Removal from Aqueous Solution Using A Forward Osmosis Membrane

Priyanka Mondal,Nick Hermans,Anh Thi Kim Tran,Yang Zhang,Yanyan Fang,Xiaolin Wang,Bart van der Bruggen

DOI: https://doi.org/10.1016/j.jece.2014.04.015

IF: 7.7

2014-01-01

Journal of Environmental Chemical Engineering

Abstract:The rejection of arsenic by a forward osmosis (FO) membrane, and the effects of relevant physico-chemical factors on the separation have been systematically investigated. MgSO4 and glucose solutions were used as two potential draw solutions. More than 98% rejection was observed when the initial As(V) concentration was 500 mu g L-1, yielding an As concentration in the permeate below the maximum contamination level (MCL). It was demonstrated that the rejection of As was higher when the membrane active layer faces the feed solution (AL-FS) compared to the rejection when the membrane active layer faces the draw solution (AL-DS). However, for As(III), it was observed that the rejection was low at lower pH (3-12.6% within pH 3-7) and oxidation of As(III) at neutral pH increased the rejection to 95.7%. Thus, oxidation before FO is suggested as an essential pretreatment for total As removal in the neutral pH range. Therefore, FO is thought to have potential as a barrier for As removal in an integrated treatment system. However, recovery of the draw solutions by using reverse osmosis (RO), nanofiltration (NF) or membrane distillation for producing As-free water is one of the critical challenges that have to be overcome before implementation in field conditions. (C) 2014 Elsevier Ltd. All rights reserved.