Enhancing the Fill-Factor of Cmos Spad Arrays Using Microlens Integration

G. Intermite,R. E. Warburton,A. McCarthy,X. Ren,F. Villa,A. J. Waddie,M. R. Taghizadeh,Y. Zou,F. Zappa,A. Tosi,G. S. Buller

DOI: https://doi.org/10.1117/12.2178950

2015-01-01

Abstract:Arrays of single-photon avalanche diode (SPAD) detectors were fabricated, using a 0.35 mu m CMOS technology process, for use in applications such as time-of-flight 3D ranging and microscopy. Each 150 x 150 mu m pixel comprises a 30 mu m active area diameter SPAD and its associated circuitry for counting, timing and quenching, resulting in a fill-factor of 3.14%. This paper reports how a higher effective fill-factor was achieved as a result of integrating microlens arrays on top of the 32 x 32 SPAD arrays. Diffractive and refractive microlens arrays were designed to concentrate the incoming light onto the active area of each pixel. A telecentric imaging system was used to measure the improvement factor (IF) resulting from microlens integration, whilst varying the f-number of incident light from f/2 to f/22 in one-stop increments across a spectral range of 500-900 nm. These measurements have demonstrated an increasing IF with f-number, and a maximum of similar to 16 at the peak wavelength, showing a good agreement with theoretical values. An IF of 16 represents the highest value reported in the literature for microlenses integrated onto a SPAD detector array. The results from statistical analysis indicated the variation of detector efficiency was between 3-10% across the whole f-number range, demonstrating excellent uniformity across the detector plane with and without microlenses.