Abstract:603 Objectives Digital Silicon Photomultiplier has recently emerged as a promising photodetector for ToF PET systems. It not only addresses a number of challenges encountered by analog SiPM such as power consumption and noise susceptibility, but also provides additional benefits including low cost and possibility to monolithically integrate the single-photon avalanche photodiode (SPAD) on the same substrate with complex circuitry[1-4]. In this study, a high-resolution, ultra-low power time-to-digital converter (TDC) was implemented to push the limit of timing resolution and improve image quality[5]. Methods Our SPAD array is fabricated in 130nm CMOS technology, using an n+/p-well junction[6]. A guard ring structure is formed to suppress the premature edge breakdown[7]. An improved passive-quenching, active-reset front-end circuit is coupled to each SPAD cell to disable noisy cells. Fig.1(a) shows the layout of our 8x8 SPAD array. Our TDC employs the Vernier Gated Ring Oscillator to improve the time resolution and reduces power consumption by a gated-mode operation. Fig.1(b) gives the TDC layout. Results The prototype chip is fabricated in standard 130nm CMOS, achieving 7.3ps resolution, 11ps precision, 1.2mW power consumption and 0.03mm2 area. A rms integral nonlinearity(INL) of 1.2LSB is obtained with the help of INL look-up-table calibration. Table I compares the performance with recent relevent works. Conclusions The design and characterization of a dSiPM prototype fabricated in a 130 nm standard CMOS is reported. It comprises of an 8x8 SPAD array and a high-resolution TDC, whose compact size makes it suitable for an array configuration. For the future work, the SPAD array and TDC will be coupled to scintillation crystals to evaluate energy resolution and time resolution for ToF PET imaging. Research Support The authors gratefully acknowledge support from the Canada Research Chair program, NSERC of Canada, CFI, FedDev Ontario, NSERC ResEau strategic network, NCE IC-IMPACTS and CMC Microsystems.

An 8-Windows Continuous-Wave Indirect Time-of-Flight Method for High-Frequency SPAD-Based 3-D Imagers in 0.18 μm CMOS

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

Time-gated SPAD camera with reconfigurable macropixels for LIDAR applications

A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications

3-D Range Imaging Using Stripe-Like Illumination and SPAD-Based Pulsed TOF Techniques

High-Precision GRO-Based ROIC Adopting Sliding Scale Average Method for SPAD Array

An 80 × 25 pixel CMOS single-photon range image sensor with a flexible on-chip time gating topology for solid state 3D scanning

Development of a High Performance Digital Silicon Photomultiplier (dSiPM) for ToF PET Imaging

FoveaSPAD: Exploiting Depth Priors for Adaptive and Efficient Single-Photon 3D Imaging

A 13-Bit, 12-ps Resolution Vernier Time-to-Digital Converter Based on Dual Delay-Rings for SPAD Image Sensor

An Indirect Time-of-Flight SPAD Pixel With Dynamic Comparator Reuse for a Single-Slope ADC

Correlation-Assisted Pixel Array for Direct Time of Flight

An 8×1k SPAD detector with TDI in 0.13μm CMOS technology

Simulating single-photon detector array sensors for depth imaging

Modeling, Simulation Methods and Characterization of Photon Detection Probability in CMOS-SPAD

A 32×32 Flash LiDAR SPAD Sensor with Up-to-1kfps Motional Target Detection by Threshold-adaptive 2D Dynamic Vision

An 8&#x00d7;1k SPAD Detector with TDI in 0.13&#x03bc;m CMOS Technology

A new single-photon avalanche diode in 90nm standard CMOS technology

Simultaneous Multifrequency Demodulation for Single-Shot Multiple-Path ToF Imaging

Low-Timing-Jitter GHz-Gated InGaAs/InP Single-Photon Avalanche Photodiode for LIDAR