Abstract:Hydraulic models have been widely used to facilitate the design, management, and operation of water distribution systems (WDS). However, model parameters including pipe roughness coefficients (PRCs) and nodal demands (NDs) must be calibrated before practical applications, and the calibration accuracy and efficiency is important to enable their wide uptake in practice. This therefore motivates intensive studies to develop approaches for model calibration focusing on either optimization algorithms or numeric methods. Although these previous studies have advanced this research area, the calibration efficiency and effectiveness need to be further improved, especially when dealing with real-world problems. To attain this objective, this paper proposes an efficient numerical approach to simultaneously calibrate PRCs and NDs for WDS. Within this method, the calibration objective function is formulated as a least-square equation, followed by the derivation of iterative formulas according to a local sensitivity analysis. These formulas allow PRCs and NDs to be iteratively updated in an efficient manner until the given convergence criteria are met. To further improve the efficiency, the pipes and nodes are grouped according to their physical properties, which allows the calibration dimensions to be significantly reduced. Additionally, within the calibration process, values of PRCs and NDs are restricted into specified ranges to ensure the calibrated results are practically meaningful. Two case studies are used to demonstrate the utility of the proposed method, and results show that this approach is able to simultaneously calibrate PRCs and NDs efficiently, with the modeled hydraulic parameter values (pipe flows and nodal pressures) matching well with observations.

Optimizing Pipe Network of Lubrication System for Accurate Oil Distribution

Research and Applications on the Optimizing and Blending of Lubricating Oil System

Energy configuration and operation optimization of refinery fuel gas networks

Efficient Numerical Approach for Simultaneous Calibration of Pipe Roughness Coefficients and Nodal Demands for Water Distribution Systems

A Fast Multiobjective Optimization Approach to S-duct Scoop Inlets Design with Both Inflow and Outflow

Numerical Simulation of the Dovetail Tee and Hydraulic Optimization of the Height Difference for Pipeline in a Liquefied Natural Gas Filling Station

The Optimization of A Low Specific Speed Pipeline Pump

Optimizing Oil Distributor Port for Low-Pulsation Cam-Lobe Hydraulic Motors

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

Sequential Multi-Objective Optimization for Lubrication System of Gasoline Engines with Bilevel Optimization Structure

Design and Optimization of Self-Compensation Oil Distributor for Hydraulic Motors

Design of Microfluidic Channel Networks with Specified Output Flow Rates Using the CFD-based Optimization Method

Optimization Design Of The Inner Radius Of The Sealing Surface Of Slipper

A Continuous Pump Location Optimization Method for Water Pipe Network Design

Optimization of Piston-Ring System for Reducing Lube Oil Consumption by CAE Approach

Inlet pipe side slot shape's impact on pump's suction: Modeling and simulation

Research on the steady‐state operation optimization technology of oil pipeline

Numerical Study on the Characteristic of the Oil Suction Pipe for a Rotary Compressor

An optimization method for uniform flow distribution in the manifold of server cabinet

An Area-Wide Layout Design Method Considering Piecewise Steam Piping and Energy Loss

Numerical Investigation on Flow Pattern of Air-Oil with Different Viscosities Lubrication