Abstract:Metal matrix composites reinforced with nano-sized particles have attracted scientific and technological interest due to the enhanced properties exhibited by these coatings. Ni–SiC composites have gained widespread application for the protection of friction parts in the automobile industry. The influence of variables like SiC content, current density and stirring speed on microhardness of nano-composite coatings has been studied. The improved microhardness was associated with the reduction in crystallite size determined by X-ray diffraction studies. The influence of incorporation of nano-SiC in hardened Ni–Co alloy matrix was also studied. It was observed that for 28wt.% Co content in the matrix the microhardness was higher compared to 70wt.% for a given nano-SiC content. This was associated to the crystal phase of Ni–28Co–SiC being fcc compared to hcp phase exhibited by Ni–70Co–SiC. The wear resistance of pure Ni, Co and nano-composite coatings was studied using pin-on-disc wear tester under dry sliding condition. The volumetric wear loss indicated that, the wear resistance of Ni–SiC nano-composite is better than that of pure nickel deposit. The wear resistance of Ni–Co composites was observed to be superior to Ni composite. The wear behaviour of Ni and Ni–28Co composite was in accordance with the Archard's law. However, the superior wear characteristic exhibited by Ni–70Co–SiC composite followed the reverse Archard's behaviour.

Study on the Anti-wear Behavior of Ni-Co/Diamond Nanocomposite Coatings

Fabrication and performance of Ni-Co-P/Si3N4 electroplated composite coatings on al-si alloys

A novel strategy for improving the wear resistance of electrodeposited Ni-diamond composite coatings by diamond surface morphology modification

Effect of Particle Concentration on the Microstructure and Properties of Electrodeposited Nickel–Diamond Composite Coatings

Influence on (Ni-P) Electroless Composite Plating with Carbon Nanotubes

Effect of Nanodiamond Content in the Plating Solution on the Corrosion Resistance of Nickel–Nanodiamond Composite Coatings Prepared on Annealed 45 Carbon Steel

Preparation, Mechanical Properties and Wear Resistance of Ni–W/SiC Nanocomposite Coatings

Wear resistance of Ni/nano-Al2O3 composite coatings by brush electroplating

Preparation of Ni-Cnt Composite Coatings on Aluminum Substrate and Its Friction and Wear Behavior

SYNTHESIS AND THE PERFORMANCE OF CARBON NANOTUBES-(Ni-P) COMPOSITES

Comparative study on the wear resistance and corrosion resistance of NiW and NiCoW composite coatings with micro- and nano-SiC particles

Effect of variations in Ni-W molar ratio on the microstructure, mechanical properties and tribology of electrodeposited Ni-W/diamond composite coatings

Friction and Wear Behavior of Electroless Wear-Resistant and Self-Lubricating Ni-P Composite Coatings

Enhanced mechanical and wear properties of Ni-W-SiC composite coatings by synergistic influence of micro-nano SiC mixture

Electrochemical Properties and XPS Analysis of Ni-B/SiC Nanocomposite Coatings

Preparation and tribological properties of Ni-P electroless composite coating containing inorganic fullerene-like WS2 nanomaterials

A Study On Abrasive Resistance Of Ni-Based Coatings With A Wc Hard Phase

Effect of Nanoscale W Coating on Corrosion Behavior of Diamond/Aluminum Composites

Electrochemical deposition and tribological behaviour of Ni and Ni–Co metal matrix composites with SiC nano-particles

Friction and wear behaviors of electrodeposited Ni-P-CNTs composite coatings on Al-alloy substrate

Diamond particles-reinforced Ni-based composite coating on Ti6Al4V alloy: Microstructure, mechanical, dynamic impact and dry-sliding tribological properties